Fusion remote & Tecnografic hooked it up

Discussion in 'Modifications/Customizations' started by ocgrant, May 22, 2020.

  1. ocgrant

    ocgrant Active Member GOLD Sponsor

    383
    Dec 31, 2006
    Miami / Ft Lauderdale
    H2O Therapy
    2006 Sundancer 48
    Cummins QSC
    Removed the old Clarion remote heads and replaced them with new Fusion N RX300 NEMA 2000 remotes. Problem was the Clarion hole was too big. Reached out to Sam at Tecnografic and he was able to make me some plates that covered the hole, finished in my black burl dash Searay original finish. Super happy they look great. Thanks Sam!!!

    IMG_1424.jpg IMG_1422.jpg IMG_1423.jpg
     
    Sam Worsham, dtfeld, gmacd81 and 3 others like this.
  2. Havana Shamrock

    Havana Shamrock Well-Known Member

    Sep 9, 2008
    Long Island. N.Y.
    2005 500DB
    2008 205 Sport
    2018 Sea Doo Spark
    Furuno Electronics
    QSM11's,
    5.0
    Honda 30HP
    Sea doo 90 HO
    That looks sharp he should bang out a few to have on hand no doubt there’ll be some interest after seeing the results here.
     
  3. ocgrant

    ocgrant Active Member GOLD Sponsor

    383
    Dec 31, 2006
    Miami / Ft Lauderdale
    H2O Therapy
    2006 Sundancer 48
    Cummins QSC
    I also did the one on my starboard arch
    IMG_1425.jpg
     
    Sam Worsham likes this.
  4. AJSB

    AJSB Member

    71
    Feb 24, 2014
    Maryland
    2000 290AJ
    2017 6.2L 350 ECT w/Bravo III Drives
    Sam does great work over there. I had them re-do my panels and I too had to add a backer to cover the larger vhf opening. Just sent him the smaller vhf mounting template and everything showed up perfectly cut and drilled to fit.
    IMG_3165.jpg
     

Share This Page

Show Sidebar