Kohler error code 62??

[Spot]

I have looked is the massive binders that come with the boat and could not find what the heck a code 62 is. The code came on after I turned off the unit and beeped. 2009 unit if that makes a differnce.

Any ideas out there?

Scott

 

[poormonkey]

Which gene controller do you have? Is this where you are seeing the EC62 I am assuming?

From what I have read EC62 is Sea Pump Pressure Fault EC62.

I could be wrong, so if you can list out where you are seeing this error and what controller you have for the gene.

If the code is correct you might have an impeller issue or a blockage to your gene.

 

[ReLAXin]

Any luck with the error 62 code. I just had this problem, 24 hrs on kohler. When I docked, it restarted manually from the unit had good flow and ran well. No strainer issues. Code isn't in the book for some reason.
Hope u found a solution.

 

[tbirdvet]

I got this code once and like the others was not listed in the manual. I did find that the battery was almost dead so did a recharge, turned off battery supply to clear the code and now all is OK. Try the battery disconnect to clear the code and see if all is OK.

 

[Maxx]

I got error code 62 today. It would run for a few minutes then shut off with this code blinking on the display. I noticed poor water flow from the exhaust. I checked the strainer and it was full off seaweed. After cleaning the strainer water still wasn't flowing freely when I opened the inlet valve. I kept the valve open, put a hose in there and flushed water through until I got little back pressure. I put everything back together, started it back up and had good water flow. Problem solved

 

[Jesse and Hunter’s Dad]

So, here we are almost four years since the last post on this issue. The boat was winterized and when I went to start it up after opening the seacock, I got the error 62 alarm. It was working like a charm last year. The boat is only three years old. I did notice that the antifreeze canister seemed fairly full but the only antifreeze added was when it was winterized. The canister is almost filled to the top. Suggestions?
Close seacock and check canister for dirt. Will do tomorrow.
Shut off battery and see if it clears. Will try tomorrow.

Any other advice? Thanks

 

[pyro]

What model do you have? Error 62 is low water flow. You can disconnect either wire from the water pressure (at least in the older models I'm familiar with) temporarily and it will actually not cause an error. However monitor you're water flow, since you could overheat it. After that I would check the impeller. Pull it out and replace it. They have a habit of breaking off parts of the rubber fins and clogging downstream components like the heat exchanger.