Middle bed piece 2nd stateroom

[Brooke Caruso]

I have a 44 sedan bridge. The 2nd stateroom has a small bedpiece to convert the 2 small twins into a queen. There is a gap/sag from the added piece to the twin bed that's there. Can anyone recommend something to put under the mattress to support/raise it 1 inch?

 

[bbwhitejr]

I have a 44 sedan bridge. The 2nd stateroom has a small bedpiece to convert the 2 small twins into a queen. There is a gap/sag from the added piece to the twin bed that's there. Can anyone recommend something to put under the mattress to support/raise it 1 inch?

On each side of the "gap," there are two plastic fixtures on each side and 2-black plastic pieces that fit into these fixtures. These black pieces span the gap between the bunks. On top of these black plastic pieces, there is a solid gray piece of plywood or plastic that span the gap. On top of this is where the cushion goes and it will not sag with all up under it in place.

Bennett

 

[Brooke Caruso]

Yes I am aware of that, but it’s still uneven. You can see where the beds are uneven when the bed is made.

 

[bbwhitejr]

Yes I am aware of that, but it’s still uneven. You can see where the beds are uneven when the bed is made.

On our 44DB when what I listed above was properly in place, it was perfectly level when made. Not sure what you have going on. Picture might help?

Bennett

 

[Brooke Caruso]

Here’s the pic of the bed. TIA!

 

[Brooke Caruso]

Bed

 

[Irie308]

Maybe redo the filler or add a topper layer to make it a bit thicker? Perhaps the original mattresses were replaced and are now thicker/taller.