Partner Sites:  www.BOEmarine.com | www.CBangler.com | www.BandofBoaters.com

Page 195 of 195 FirstFirst ... 95145185193194195
Results 1,941 to 1,949 of 1949
  1. #1941
    Join Date
    Oct 2009
    Location
    Lake Erie
    Boat
    Sea Ray
    Details
    1999 Sundancer 330
    Engine(s)
    7.4 MPI
    Posts
    940

    Re: Official 330 Sundancer Thread

    Quote Originally Posted by Saverio View Post
    morning all,

    I got a new glowmex antenna and started installing it. has anyone ran wires from the arch to the cabin? was thinking of going down port side arch? has anyone had success?

    saverio
    It's possible. It's a pain in the ass, but possible. I've done it twice, once to run new coax from the shore outlet to a DirecTV box in the TV cubby, and once to run Cat-6 from my Rogue Wave wifi antenna on the arch to the TV cubby. Both cables follow the same path.

    From the arch run the cable horizontally about even with the top of the hull forward. There is a wall in the storage compartment in front of the passenger seat that the cable will pass over before turning 90 degrees and heading straight down. If you reach over the wall, you will be able to feel the back side of the upper storage compartment in the head.

    In the storage compartment under the sink in the head, there is a narrow board serving as the aft wall of the compartment held in place by a couple of screws. Remove them and you should be able to get the end of the wire you fished down from the cockpit. You can run the cable across the floor with the water pipes through the bulkhead at the bow end of head's storage compartment.

    Remove the refrigerator. There are several screws perhaps with screw head covers in the flange of the fridge. Remove the screws, slide out the fridge and be amazed at the wasted space behind the fridge and galley cabinets. I've joked you could hide a body in that space.

    From here you should be able to run the wire to aft section of the bulkhead where the TV cubby resides. I was able to feed the wire into the bottom of the storage cabinet below the TV cubby, but ended up drilling a 1/2" hole in the back corner of the shelf to feed the wire up. Good thing I went large with the hole through the shelf as a couple years later I used the same hole for the Cat-6 to feed my wifi router.

    Hope this helps.
    Last edited by LTD.330; 02-21-2017 at 12:59 PM. Reason: Fixed a couple of typos

    A boat needs no justification ... just water

    Pete.

  2. #1942
    Join Date
    Aug 2010
    Location
    Long island new york
    Boat
    Sea ray
    Details
    1995 330 DA
    Engine(s)
    Twin 454 Webber Carbs V drives Fresh water cooled
    Posts
    883

    Re: Official 330 Sundancer Thread

    Pete

    thanks for your help going to try later today. was hopping I didn't have to remove the fridge. I have two styles of snakes to try.

    saverio
    [/SIGPIC]1988 Sea Ray EX 39 454 merc. Westerbeke 8kw
    Former boats
    1982 Sea Ray 31 Vanguard Ex
    1979 Sea Ray 30 EX
    1979 Sea Ray 26 sundancer
    1984 wellcraft Nova 22

  3. #1943
    Join Date
    Aug 2009
    Location
    Long island , NY
    Boat
    Sea Ray
    Details
    1997 330 sundancer
    Engine(s)
    twin 454's, Carb, V-Drives
    Posts
    5,412

    Official 330 Sundancer Thread

    Quote Originally Posted by Saverio View Post
    Pete

    thanks for your help going to try later today. was hopping I didn't have to remove the fridge. I have two styles of snakes to try.

    saverio
    Severio,
    I ran Directv coax up the port side of my boat when I added the M1 dish. I did not follow the same path as Pete. I ran the wire down the port side of the arch. I pulled the cockpit fridge & ran the wire fwd through a channel in the carpet in the storage compartment fwd of port seat in cockpit. I pulled the Microwave & was able to snake the wire from the cockpit to this area. From there I went fwd, the port cabinet interior lining actually had a zipper in it. I got the wire to the bulkhead just fwd of the galley sink then had to fish it down into the compartment that holds the TV. I'm not sure what you will need to do to actually get it to the glomax amplifier but I am sure you will figure it out. Good Luck

    Sent from my SM-J320V using Tapatalk



    Cheers!!

    Todd


  4. #1944
    Join Date
    Aug 2010
    Location
    Long island new york
    Boat
    Sea ray
    Details
    1995 330 DA
    Engine(s)
    Twin 454 Webber Carbs V drives Fresh water cooled
    Posts
    883

    Re: Official 330 Sundancer Thread

    Todd

    thanks was thinking of that route. You have to pull the freezer to get the wires out of the arch?

    I have one of those poll type snakes where you can keep screwing on lengths. was going to try that and see where I end up.

    I heard your close to me? I just moved to Leeward cove

    saverio
    [/SIGPIC]1988 Sea Ray EX 39 454 merc. Westerbeke 8kw
    Former boats
    1982 Sea Ray 31 Vanguard Ex
    1979 Sea Ray 30 EX
    1979 Sea Ray 26 sundancer
    1984 wellcraft Nova 22

  5. #1945
    Join Date
    Aug 2009
    Location
    Long island , NY
    Boat
    Sea Ray
    Details
    1997 330 sundancer
    Engine(s)
    twin 454's, Carb, V-Drives
    Posts
    5,412

    Official 330 Sundancer Thread

    Quote Originally Posted by Saverio View Post
    Todd

    thanks was thinking of that route. You have to pull the freezer to get the wires out of the arch?

    I have one of those poll type snakes where you can keep screwing on lengths. was going to try that and see where I end up.

    I heard your close to me? I just moved to Leeward cove

    saverio
    Pulling my cockpit fridge was super easy. I just needed to remove the door to clear the helm seat base. Then you can feed it right down & easily find the channel fwd in the carpet in the port side locker.
    Yes, I am close to you. I am in Baypoint Marina (Tabats on some charts still) in Bluepoint.

    Sent from my SM-J320V using Tapatalk



    Cheers!!

    Todd


  6. #1946
    Join Date
    Aug 2010
    Location
    Long island new york
    Boat
    Sea ray
    Details
    1995 330 DA
    Engine(s)
    Twin 454 Webber Carbs V drives Fresh water cooled
    Posts
    883

    Re: Official 330 Sundancer Thread

    Todd

    I just stopped by during lunch a im totally bummed. I pulled the ice machine and yes lots of space behind it. I ran a snake into the carpeted compartment and I had issues getting out from there. I tried following the wiers that left but kept getting blocked. I checked the bathroom and found no access to the area. I removed the microwave and found the back wall isn't removable. that area is all sealed????
    [/SIGPIC]1988 Sea Ray EX 39 454 merc. Westerbeke 8kw
    Former boats
    1982 Sea Ray 31 Vanguard Ex
    1979 Sea Ray 30 EX
    1979 Sea Ray 26 sundancer
    1984 wellcraft Nova 22

  7. #1947
    Join Date
    Aug 2009
    Location
    Long island , NY
    Boat
    Sea Ray
    Details
    1997 330 sundancer
    Engine(s)
    twin 454's, Carb, V-Drives
    Posts
    5,412

    Official 330 Sundancer Thread

    Quote Originally Posted by Saverio View Post
    Todd

    I just stopped by during lunch a im totally bummed. I pulled the ice machine and yes lots of space behind it. I ran a snake into the carpeted compartment and I had issues getting out from there. I tried following the wiers that left but kept getting blocked. I checked the bathroom and found no access to the area. I removed the microwave and found the back wall isn't removable. that area is all sealed????
    Really? I was able to run a snake right thru. I have like a 10' flexible metal stake. The back of mine was not sealed. I had 2 galvanic isolators mounted back there.

    Sent from my SM-J320V using Tapatalk



    Cheers!!

    Todd


  8. #1948
    Join Date
    Aug 2010
    Location
    Long island new york
    Boat
    Sea ray
    Details
    1995 330 DA
    Engine(s)
    Twin 454 Webber Carbs V drives Fresh water cooled
    Posts
    883

    Re: Official 330 Sundancer Thread

    Todd,

    I finally got it done. I went in back wall of the cabinet and unzipped the pounch, I than ran the rigid snake back to the aft and it came out under the sink in the cockpit. I turned it all on and I picked up about `13 channels cbs being the main.

    saverio
    [/SIGPIC]1988 Sea Ray EX 39 454 merc. Westerbeke 8kw
    Former boats
    1982 Sea Ray 31 Vanguard Ex
    1979 Sea Ray 30 EX
    1979 Sea Ray 26 sundancer
    1984 wellcraft Nova 22

  9. #1949
    Join Date
    Dec 2011
    Location
    Knoxville, Tn
    Boat
    Sea Ray
    Details
    1997 330 Sundancer
    Engine(s)
    310 hp 454s w/ ZF Hurth Transmissions
    Posts
    8

    Re: Official 330 Sundancer Thread

    Can someone measure the anchor locker hatch? I need to order new gasket material and can't get down to my boat right now. Just need all three sides, so I can order enough gasket, I'm thinking 4 feet should do it, but want to make sure.

    Thought I might be able to get it off of the parts manual , but
    - the gasket doesn't show the length needed
    - the listing for the hinge shows a 96" hinge......pretty sure that hatch isn't 8 feet long, haha.
    Guess you were just supposed to order a huge hinge and then cut it to length.

Similar Threads

  1. Official 370 Sundancer thread
    By Sea Ray Mark in forum Sport Yachts/Yachts
    Replies: 2608
    Last Post: Yesterday, 08:27 PM
  2. Official 290 Sundancer Thread
    By biggerboatitis in forum Sport Cruisers
    Replies: 921
    Last Post: 02-22-2017, 08:05 PM
  3. Official 240 Sundancer Thread
    By Shining in forum Sport Cruisers
    Replies: 1864
    Last Post: 02-05-2017, 06:25 PM
  4. Official 370 Sundancer thread
    By connie garcy in forum Sport Yachts/Yachts
    Replies: 7
    Last Post: 08-01-2011, 06:12 AM
  5. Is there an official 300 Sundancer Thread?
    By Bam073 in forum General Discussion
    Replies: 2
    Last Post: 03-08-2009, 09:28 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •