Results 261 to 266 of 266
-
05-20-2013, 01:42 PM #261
- Join Date
- Aug 2010
- Location
- Annapolis, MD - Middle Chesapeake Bay
- Boat
- Sea Ray
- Details
- 2005 300DA, Garmin 740s w/Vision Charts and GMR18HD RADAR
- Engine(s)
- 5.0MPI w/BIIs, Kohler 5E Generator.
- Posts
- 723
Re: 310 Sundancer Thread (2007 & newer)
Mine was. I did a direct replacement with minimal relocating. One thing to note is that (at least in my boat) Sea Ray did not include much extra length or service loop on the wires connected to the charger, so I had to move slightly up and left in order to get enough lenth to reach the new configuration. Secondly, do yourself a favor and take the charger with you to your local auto store to make sure you find crimp-on closed loop wire ends that will fit both the gauge of the wire itself (I only had crimp on ends for smaller gauge wires), and also that the hole in the crimp on closed loop connector will fit over the nut/bolt terminals on the charger (I ended up having to drill out the end of the connector a bit). Also unlike the old charger, my 1240p had plastic dividers between each post for the + - Ground and 3 bank setup. The closed loop connector has to fit inbetween those too (I almost had to file them off a bit to reduce the diameter enough to fit between the dividers. All doable... just take it with you so you dont have to make 3+ trips for the right parts you thought you had already :)
Wishing I had a picture for you right now so you could see the dividers I'm talking about. Either way its no big deal to work around. I would say probably an hour to 1.5 hour job, if you have everything ready and in place for the job.
If you have room for the remote monitor screen, it would be a nice addition. I have to tip up my cockpit floor to peek down and see how close to fully charged my batteries are if I'm charging from the generator on the hook. May end up adding the remote monitor screen if I can find a way to snake up the cable to my cockpit battery control switch area. (Which I already know has minimal slack line to work with in the wires, thanks to Bill zz13 who attempted to take his out for another project).
JamesLast edited by JimFromMD; 05-20-2013 at 01:44 PM.
-
05-20-2013, 01:44 PM #262
- Join Date
- Nov 2009
- Location
- Summersville Lake
- Boat
- SeaRay
- Details
- 2010 330 Sundancer, cockpit grill, thru-hull L.E.D. Lights, Raymarine c-80
- Engine(s)
- Twin 350 Mag Horizen, V-drives with bow/stern thrusters
- Posts
- 6
Re: 310 Sundancer Thread (2007 & newer)
Just ordered a 1250p!! U busy this weekend Jimbo???? Lol
-
05-20-2013, 01:51 PM #263
- Join Date
- Aug 2010
- Location
- Annapolis, MD - Middle Chesapeake Bay
- Boat
- Sea Ray
- Details
- 2005 300DA, Garmin 740s w/Vision Charts and GMR18HD RADAR
- Engine(s)
- 5.0MPI w/BIIs, Kohler 5E Generator.
- Posts
- 723
-
05-20-2013, 02:01 PM #264
- Join Date
- Nov 2008
- Location
- Southern WV
- Boat
- Sea Ray
- Details
- 2007 310DA
- Engine(s)
- Twin 350Mags, V-Drive
- Posts
- 1,866
Re: 310 Sundancer Thread (2007 & newer)

Summer Daze 3
2007 310 DA, 350 Mags, V-Drives
Tender: 2007 Triumph 150CC
Previous boats: 1999 270 SE, 454, Bravo 3; Bryant 212, 350, Alpha 1; Bryant 160, Yamaha outboard. All bought new off the showroom floor!
-
05-20-2013, 02:52 PM #265
- Join Date
- Nov 2009
- Location
- Summersville Lake
- Boat
- SeaRay
- Details
- 2010 330 Sundancer, cockpit grill, thru-hull L.E.D. Lights, Raymarine c-80
- Engine(s)
- Twin 350 Mag Horizen, V-drives with bow/stern thrusters
- Posts
- 6
Re: 310 Sundancer Thread (2007 & newer)
JimFromMD....c'mon!!!! Cleanest lake east of the Mississippi!!! Definitely a little slice of heaven! Jimbo....I know you r buddy!!! Guess I could turn the on board genny just to charge the batteries...or do I won't to scrap and by the 30 amp charger??? Confused!!!!
Last edited by IT'LL DEW; 05-20-2013 at 05:04 PM.
-
05-20-2013, 03:05 PM #266
- Join Date
- Nov 2008
- Location
- Southern WV
- Boat
- Sea Ray
- Details
- 2007 310DA
- Engine(s)
- Twin 350Mags, V-Drive
- Posts
- 1,866
Re: 310 Sundancer Thread (2007 & newer)
Last edited by JimG; 05-20-2013 at 04:23 PM.

Summer Daze 3
2007 310 DA, 350 Mags, V-Drives
Tender: 2007 Triumph 150CC
Previous boats: 1999 270 SE, 454, Bravo 3; Bryant 212, 350, Alpha 1; Bryant 160, Yamaha outboard. All bought new off the showroom floor!
Similar Threads
-
340 SUNDANCER THREAD
By jim696 in forum Sport CruisersReplies: 942Last Post: 05-24-2013, 07:01 PM -
Official 330/350 (2008 and newer) Thread
By JV II in forum Sport CruisersReplies: 272Last Post: 05-11-2013, 07:48 PM -
2007 290 Sundancer
By Nighwind_15 in forum Sport CruisersReplies: 8Last Post: 10-06-2010, 07:02 PM -
38' 2007 Sundancer
By MHillman in forum Sport Yachts/YachtsReplies: 17Last Post: 06-24-2010, 12:47 PM -
Regarding a 320 Sundancer thread
By RE/LAX in forum Sport CruisersReplies: 1Last Post: 01-05-2010, 11:19 PM




Reply With Quote
Your 2009 Searay "should" have the smart type. The one I had was not a smartie, I spoke with the guys who made it (if I remember it was Raritan) They said "They made these so well that they're still...
Battery charging query