Great boat in excellent condition! "First Mate" says it has to go before winter... $16,900
Engine: Mercruiser MCM 5.7 Liter (2 BBL.) GM 350 V-8 Thunderbolt 5 Ignition Alpha I (250 HP) Gen II, fresh water cooled (heat exchanger replaced 5 seasons ago); this is the optional larger engine. Dual batteries (replaced 4 seasons ago). Power steering (pump replaced 3 seasons ago). Halon fire suppression system.
Below deck: sleeps 2 in V-berth and 2 in mid-cabin, private porta-potti/pump out head and macerator, 110VAC/12VDC refrigerator, butane stove. Installed Perko rod holders in gunwales and blue LEDs under swim platform. Bottom painted, outdrive and trim tabs painted and new zincs.
Above deck: full camper canvas, dockside power with cord and pressure water system for sink in cabin and aft shower.
Electronics: Garmin GPSmap 492 chart plotter (software updated last season), Horizon Standard NOVA GX2330S VHF radio (new antenna last season).
Trailer: EZ-Loader tandem, GVWR = 6,500 lbs, with surge brakes and fenders. New 5" rollers and hardware on aft arms.
I have a 2003 240 sundancer and i was just wondering if anyone else has had trouble with the switch pad that controls all of the minor functions like bilge pump, lights etc. Since I'm located in Australia i'm finding it hard to track down a replacement. Anyone point me in the right direction, are these parts still available in america and if so where?
Neither can we. In fact we often experience a power fade then surge when engine is over 3,600 rpm. We've had the fuel tank cleaned, fresh fuel and new filters and new high pressure fuel pump, but still the same fade and surge. Runs for hours at 3,400 rpm beautifully. Has anyone else had this problem?
well , the numbers at boattest are simply fake. every 240 owner can confirm that 47 mph measured by gps are simply not in the cards with the 5.0 mpi. the highest i ever reached by gps was 40 mph , and that was with just me and little fuel .
I ordered new side curtains from great lake (former owner had lost), and now i have a complete canvas.
But, previous owner had lost / destroyed canvas frame also, and i`m gonna make new ones from stainless steel.
Please, could someone take a measurement from front and rear, the strait part of frame (approx), from side support to the point where curve begin.
Those measurements are marked in the picture. I`ll really appreciate if someone will help me with the measurements.
Thx, Miikka Canvas frame.jpg