Results 1 to 5 of 5
  1. #1
    Join Date
    Apr 2010
    Location
    Netherlands
    Boat
    Sea Ray
    Details
    400 sedan bridge
    Engine(s)
    twin Caterpillar
    Posts
    15

    SeaRay 200 leak...where???

    Hello!

    I own a SR 200 signature from 1994 with a Mercruiser 4.3LX engine (Alpha one drive).

    I have a leak, but can't detect it. When i'm on the water with the boat (fast or slow) everything stays dry, but when i leave the boat in the water and return the next day, the water is almost as high as my battery! I checked all the waterhoses in the engine-compartiment, but they are all dry. I took the boat out of the water now witrh water in the compartiment, so i thought that i would see the water coming out, but everything stays dry!???!

    What can this be??? I don't think that it's the engine, but in my opinion it can only be the Alha One drive or the boatplug. I checked the plug and it's NOT leaking...

    Thank you!!!

  2. #2
    Join Date
    Apr 2009
    Location
    PA
    Boat
    Sea Ray
    Details
    1999 260DA ShoreLand'r Galvanized
    Engine(s)
    5.7L EFI Bravo III
    Posts
    7,387

    Re: SeaRay 200 leak...where???

    Well, the obvious choice for water coming in that fast would be a hole in shift cable bellows or drive shaft bellows. Another thought would be a leaking thru-hull such as a depthfinder.
    Dennis
    1999 260DA 5.7L EFI B3
    2000 ShoreLand'r
    Past & Other Current Boats: Not enough room!
    1998 GMC K2500 Suburban 6.5 Diesel - Tweaked "Just a bit"
    "Exceeding your expectations since 1936"

  3. #3
    Join Date
    Aug 2011
    Location
    cape cod mass
    Boat
    sea ray
    Details
    2006 sea ray 280
    Engine(s)
    Twin 5.0's with B3's closed cooling with Kohler 5E
    Posts
    304

    Re: SeaRay 200 leak...where???

    Mirror and lighting. Wait and watch

  4. #4
    Join Date
    Jul 2007
    Location
    Hemet, CA
    Boat
    SeaRay
    Details
    1978 21' Cuddy
    Engine(s)
    Mercruiser 260 A-1 O/D
    Posts
    89

    Re: SeaRay 200 leak...where???

    Just a suggestion:

    Had a leak - couldn't figure it out (they are evasive). No leak underway but water coming in while drifting or at anchor, but only with 3-4 people in the boat. I trailer the boat, easy to see there was no hull damage and the water was only in the forward section, dry in the engine compartment.

    Finally figured out the only thruhull fitting below waterline at anchor or drift was the cooler drain tube (that white, crappy, plastic stuff) that had 'cracked' where it couldn't be seen. Under normal conditions with only one person in the boat the thruhull was above waterline. With three or four on board the fitting just barely got to waterline, just enough to let water in back to the crack. Underway the thruhull fitting was above waterline so there was no leak. Since I do not use ice in the onboard cooler (I use either 'blue ice' or frozen milk jugs so there is no melting water to drain) it took quite some time to find the problem and it was only because one day I forgot the frozen jugs and bought bagged ice at the marina which melted and drained exposing the crack in the hose.
    Last edited by njmello; 09-16-2012 at 10:57 AM. Reason: spelling
    If you are not the lead dog the scenery never changes.

    NJMello
    1978 21' SeaRay Cuddy
    w/260 Mercruiser I/O
    "MelloW DayZ"

  5. #5
    Join Date
    Oct 2011
    Location
    Portland, or
    Boat
    Sea Ray
    Details
    1984 Sea Ray Sundancer 270
    Engine(s)
    Volvo Penta 5.7l, Merc Cruiser top half w Alpha 1 Outdrives
    Posts
    163

    Re: SeaRay 200 leak...where???

    I had a similar issue. Then my shifter cable broke in the outdrive. When we pulled the out drives we found a seal that was obviously shot. put the outdrive back on and new seal .....no leak now. we had checked bellows thru hulls etc. Would have never found it if the shifter cable had not broken!

    Good luck Mike

    Quote Originally Posted by 400sedanbridge View Post
    Hello!

    I own a SR 200 signature from 1994 with a Mercruiser 4.3LX engine (Alpha one drive).

    I have a leak, but can't detect it. When i'm on the water with the boat (fast or slow) everything stays dry, but when i leave the boat in the water and return the next day, the water is almost as high as my battery! I checked all the waterhoses in the engine-compartiment, but they are all dry. I took the boat out of the water now witrh water in the compartiment, so i thought that i would see the water coming out, but everything stays dry!???!

    What can this be??? I don't think that it's the engine, but in my opinion it can only be the Alha One drive or the boatplug. I checked the plug and it's NOT leaking...

    Thank you!!!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •