I am new to the club so please be gentle. I have a 93 370 dancer which lost vacuum pressure over the weekend, the water system still works, I was able to run a snake all the way to the holding tank, and when I remove the line to the holding tank water drains by gravity
I am assuming it is a valve or a pump motor that creates the vacuum as there is nine when the foot pedal is depressed
I'm going to recommend start by replacing the 4 duck bill valves that are located 2 in the inlet and 2 outlet of your Vacu pump.
These are often sold in a 2 pack so, you'll need to buy 2 to get all 4.
1 1/2 inch should be the size.
I'd recommend to pump-out, add water, pump-out again several times because, your needing to remove the black water lines on either side of the pump to access the duck bill valves.
Its not all that bad, if your holding tank is as empty as possible..wear gloves ;)
Might be best to remove the pump and inspect/clean it on the bench.
Last edited by Air O'Nautical; 01-02-2017 at 11:53 AM.
Can you hear the pump running, if not make sure head breaker is on. Also make sure power is actually getting to the pump. You will most likely have to replace duck bills since you ran a snake thru them, they are one way and probably damaged them when running snake.