Dash panels failing

20190529_192546.jpg
20200516_143014.jpg
I bought mine from Hyannis Marine and sent the black covers to tecnografic to finish. They are held on with little screws covered by silicone. A couple of people have told me through the years that the switches in the pads going bad shorts out the eim's. Not sure if its true but I replaced mine a couple of years ago just in case. I kept the old ones for spares. Wasn't sure how long replacements would be available.
 
FYI... Sea Ray has gotten new versions from another company. There are lot's of them in stock at Sea Ray - your local dealer can get them. They're about $350/each.
 
mmcguire2002 said:
+1 on wanting to know where to source them.
Click to expand...

We produce a black set for the 340SDA. They are CNC cut out of Black ABS. We have the main gauge panel, center helm, radar pod as well as Ray215 filler panels for swapping out to new smaller units.

The main gauge is cut for the stand 5-gauge Smartcraft configuration. The Radar and Center Helm panels are available as solid panels or we have them pre-cut for Raymarine Axiom 9s (for my use) but others can be custom cut. All panels are pre-drilled to use the original screw holes.

If you are interested in getting more info get my info from www.covemarine.com and give me a call or PM here on CSR.

Thanks,
-Kevin
 
Shenanigans77 said:
https://www.ebay.com/p/1172239511

Hyannis Marina. They usually have both sides in stock. Mine had a crack in the epoxy in the back and on a hard rain some water snuck past the cockpit cover and got behind it......Poof
Click to expand...
Thanks for this. They did have both in stock and are shipping to me tomorrow. Hopefully I can pop them in the weekend and be good to go!
 
You must log in or register to reply here.

Forum statistics

Threads
113,116
Messages
1,426,384
Members
61,028
Latest member
ddbyrd329
Back
Top