Recent Activity

Activity stream for all registered members at Club Sea Ray.

  1. Overvolted posted a new thread.

    Oil level showing overfull

    1987 Sea Ray 268, big block Mercruiser. Went to the boat tonight to change the oil, when I pulled the stick it showed way over filled....

    20230606_202244.jpg

    Forum: General Maintenance/Repair Questions

    Jun 7, 2023 at 1:30 AM
  2. boatman37 replied to the thread Singing The National Anthem.

    Well look at the direction we are headed. If anyone doesn't think we are in worse shape than 4 years ago then wow. Our economy is...

    Jun 7, 2023 at 1:00 AM
  3. Nater Potater liked jamesrladd's post in the thread Replacing a straight shaft engine coupler in the water.

    Thanks for all your feedback. I was looking to worst case my potential outlay as the seller is fairly motivated in his pricing. I need...

    Jun 6, 2023 at 11:32 PM
  4. Cdillerud replied to the thread Singing The National Anthem.

    Based on…what facts?

    Jun 6, 2023 at 11:32 PM
  5. Steve S attached a file to the thread Joke Thread.. post 'em if you got 'em.

    [ATTACH]

    upload_2023-6-6_22-25-6.png Jun 6, 2023 at 11:25 PM
  6. The Bill Collector replied to the thread OFFICIAL - 450DA Owner's Thread****.

    Are you spraying the paint on...

    Jun 6, 2023 at 11:21 PM
  7. John E3 attached a file to the thread Potential Engine Pull Out.

    [ATTACH] Water intrusion on 5 cylinders, probably over many years. Worst ones hit 170psi and consistant. I'm putting rebuilt heads on...

    20230606_204558.jpg Jun 6, 2023 at 11:21 PM
  8. dtfeld liked SKybolt's post in the thread Glomex Antenna Amplifier Wanted.

    @ttmott Tom this may be it https://www.glomex.us/portfolio-items/manual-a-b-amplifier/?portfolioCats=47

    Jun 6, 2023 at 11:19 PM
  9. dtfeld replied to the thread Speaker wire ga required?.

    Correct. 140W each @2ohms into 4 speakers. I think 14 ga out to be just fine.

    Jun 6, 2023 at 11:18 PM
  10. John E3 replied to the thread Replacing a straight shaft engine coupler in the water.

    I could have used that level of survey. Ran great, responsive, close on wot, but 1250 hrs. Water intrusion on 5 cyl. Both exhaust...

    Jun 6, 2023 at 11:15 PM
  11. Nater Potater liked my3sons's post in the thread Replacing a straight shaft engine coupler in the water.

    I can tell you that on my boat there is enough room to replace a complete tides seal assembly (on the hard) by sliding the shaft back...

    BE1CAC08-46C6-4013-A38E-455CF9642D2F.jpeg Jun 6, 2023 at 11:10 PM
  12. Nater Potater replied to the thread Lesson's learned for re-wire of thermostat- 320DA.

    Yes, but you got it done. Good on you!

    Jun 6, 2023 at 10:59 PM
  13. Nater Potater liked WV 320 Dancer's post in the thread Lesson's learned for re-wire of thermostat- 320DA.

    I had to replace my AC unit and the new 16,000 BTU from Citimarine uses a 7-pin wire for the thermostat. It is too big to pass through...

    Jun 6, 2023 at 10:59 PM
  14. Lazy Daze replied to the thread Where is water fill located on my 1998 215ec?.

    Sure, it's a pretty common thing to do. You don't really need the primer since you're starting with a painted surface - don't think it...

    Jun 6, 2023 at 10:55 PM
  15. WV 320 Dancer posted a new thread.

    Lesson's learned for re-wire of thermostat- 320DA

    I had to replace my AC unit and the new 16,000 BTU from Citimarine uses a 7-pin wire for the thermostat. It is too big to pass through...

    Forum: Sport Cruisers

    Jun 6, 2023 at 10:52 PM
Loading...
Show Sidebar