easiest way to find out what is what is to disconnect a positive lead from a battery and see what works.
If battery`s are wires in parallel most likely there cranking on position 1 and house on position 2
other engine does not have the batterys parallel
Should you experience this condition DO NOT USE A HAMMER, even a brass hammer will do damage if you pound on the shaft too hard.
There is a tool you can easily modify to safely remove the cylinder.I have found that most other tools do not fit or work .
A pitman arm remover tool . With a slight...
Most chargers are hooked directly to the batteries so the switch position does not matter.
Only you can determine how the batteries are hooked up and even IF you have a house system.
If you used position 1 and it worked ok for that day and then used number 2 position and it didnt, that could...
A can of Power-Tune and your hand is all you need to install the lock ring.
Once the bellow is sitting in its groove in the housing you install the ring
just thank all americans who voted for Sleepy Joe.
But in reality how could anyone even vote for Federman anyway knowing what he wants in the justice system and open drug injection sites.
If it is cable type,
#1 usually from the upper to the lower, from the lower to the drive/rudder.
#2
from the upper to the drive/rudder, from the lower to the drive/rudder