Search results

I am at a total loss as to how to my fuel filters properly. Each engine has a double Racors, then a wall mounted MAN wall mounted fuel filter, then to dual Pre-filters on the engine. There is a hand priming pump between the MAN wall mounted Fuel Filter and the engine Pre-filters. Can...

I got a question to you guys with a wireless "Yacht Controller" setup. Is your setup basically an added extra helm station and the "Yacht Controller" controls the added helm station wirelessly? I chose the "install yourself" option and I'm pretty sure I can handle it. Just didn't realize...

Other than "don't do it", anyone got any advice as to how or if you can treat marina water (raw) to fill on board water tanks? Marina Dock water was turned off middle of Nov. Would like to use boat during the winter. I'm down to 65% of my 200 gallon fresh water tank.

The FM antenna for the Helm 12 Volt FM Radio in my boat is buried behind the helm electronics. Needless to say, I get very crappy reception. You guys got a better solution? Bill

What do you guys think of this look? one with side strato glass panel and one without. Kind of like what Riviera is doing with their Belize 54. 2 poles at the rear.

Can anyone identify the model? The extended roof line has got me perplexed.

You guys ever dealt with a system that hooks the positive side of the battery to ground and then the negative side of the battery to your wiring harness? Crazy! Been helping a friend get a 1960 MG started that has been sitting for 15 years. His brother died a few years back and the car had...

Just wanted to let you guys know I am a sponsor on this site and we have these products for sale. Thanks for the interest. http://parkitwithbill.com/

Anyone interested in a pair of these? I was thinking about selling them for $400...

My last boat was a 48 Sundancer, If I wasn't paying attention when filling the tanks, when the tanks got full, fuel would spew out the fuel tank vent line openings out the side of the boat. Has there been a solution to this issue? Can you momentarily valve that line off and redirect the vent...

Just curious, how many of you would pay $1mil for this boat...

Anybody got an opinion on what the characteristics of a 48 Sundancer with Arneson Drives would be like? Would it work or does the hull design have to be known from the start? Can you convert a V-Drive boat to surface drives?

I am really intrigued by the 1996 -1999 63 Sundancers with the Arneson Surface drives and every once and a while I have seen where boats for sale on Yacht World and such are listed with Surface Drives and a hydraulic platform. I can't picture how a boat with Surface drives can also have a...

Anyone had experience with MTU's? Where would they fit in with CAT's and Cummins as far as reliability, cost to repair and so forth? Thanks Guys. Looking at a 63SS with MTU's.

If this 2001 680 SS goes for over $1 million. How much would this 2001 480 SS go for? Just a thought?

If one was to buy any one particular boat that offered 4 diesel engine options ranging from 350hp to 500hp, which engine option would get the best fuel mileage?

I am trying to figure out how much my boat weighs. If you go to the Sea Ray website and look at the spec sheet for a 2005 48 Sundancer, it says the boat weights 28,000 lbs. Seems a little light, but that is what it says. If you look at the spec sheets for the 2006 or so thru 2011, it says...

I was informed by my local Sea Ray dealer that since my boat is still in production, I can get all new seat skins for all my exterior vinyl cushions. It involves 9 different cushions. 6 in the cockpit and 3 in the helm area. This does not include the 2 helm chairs. My boat is a 2005 and the...

I have read thru every post that I could find on the this subject. However, haven't been able to find an answer to this question. I would like to install an inverter for powering the 120 volt outlets on both sides of the boat so that I don't have to run the Gen. while under way. The main...

Could you guys give me your opinion on how to make these seal look new again. Dig it all out and re-seal? What is the sealer I should use? What does Sea Ray use? Thanks in advance for all the help guys.