Search results

Next time a heavy rain comes sit in the boat with a flash light.

I am working on re-bedding some HW items, a couple of pieces not sure of how to remove the drain in the cabin access steps (I have an idea but before I rip a panel off I want to ask) and the windshield. Also the front hatch looks like it has been sealed previously (aftermarket sealant squeezed...

It it maybe a good idea what some engineer calculated and had the mold transfer to the tire.

post a pic

Hi, time for me to refinish the exterior wood, what have you guys\gals used that lasted a very long time and durable?

Anyone know a source for these quickie put up carport trusses? they are 3x3" I think or close to it, I don't want a whole kit I'll make my own legs. Prefer Georgia area. thanks,

Look at the drain hoses under rear of engine hatch drains and the rub rail if there is a gap on top water can get in thru the rivet holes.

So it came up during lunch time conversation that enough ice melts in the summer time to be able to traverse from eastern Canada to Alaska via the mouth of Hudson Bay and Beaufort Sea and rest of the channels. It became very heated topic I just sat back and thought no way enough hair spray was...

Hi, Anyone on here ever weigh a 70's Ford F600 cab chassis truck? no bed, 14' wheelbase.

Ok I see it, have to buy from a retailer, $65 from iboats.com Should I caulk on the top of the aluminum rail? and leave bottom open for drainage? Maybe seal bottom of bow area only? I know it has been questioned here on other posts mostly stated leave bottom with no caulk. I had one area about...

Hi, For a 268 bump rail plastic insert anyone have the correct part number? A Taylor item?

Oil look normal? have you done a compression and leak down test on cylinders? vacuum check? sparks all look the same? when you do run it and it warms up pull off the valve cover breather smoke coming out? Just some preliminary items to check for general health of the engine...

You have to share pics... I want to see what space you have to work with.

You need a steam cleaner, not a hot water, not an electric, but a kerosene\diesel heating type. No need for high pressure low throttle will do most of that crud will melt off. Follow up with some elbow action....

Frank, I understand what you are saying and appreciate you sharing it. I also know that SR (others also) decks are cored and transoms have a sheet of plywood in them. Just my preference to have least amount of cored structure. I had read previously and can't find it that Brunswick...

I am considering looking at a 1990 310 DA and do not want wood cored hull.

Hi, what year did Sea Ray add wood coring to hulls?

I found it

More like a work boat, huge props for the size boat almost tug like.

Last year I was driving back from Arizona I came up behind what looked like a former Navy utility\work boat (gray) being towed by a sprinter van. I'd say approx. 20' long 8'6" ish beam. It had 2 huge propellers under it probably 2' dia each. Console almost aft. Looked like engines mid ship...