I have 2 engine hatch actuators from my 2006 340 for sale. I replaced mine with new due to fracturing the bottom mounting point while pulling motors changing out transom assemblies.
Couldn't find any so had the fractured one repaired while awaiting the marina to replace the one they broke...
Howdy all - Looking for a hatch lift actuator for a 2006 340 Sundancer. It is an 18 inch actuator that opens to 24.5 inches. Any out there to be had? Acculift is out of business. Anyone used another direct replacement brand?
Thanks, Korkie
Good morning - Has anyone purchased parts from Powerhouse Marine in Miami recently?
Looking to get 2 tramsom assemblies and just doing some homework as I have not purchased from them in the past. Thanks in advance.
Removed the SC5000 and upgrded to VV703. Got everything all set up but cannot figure out where or how to get the gph to display on the VV for the Port Side. Displays the Stbd motor as well as displays both motors gph on my garmin GMI20. So the information is there, I just cannot find where...
2006 340 full set of slant back canvas for sale. (less bimini's) Replaced ours with custom made polycarb front enclosures and a camper enclosure with screens. $250.00 + shipping.
Hoping everyone is as well as can be. 2006 340 with 496mags. Upgraded from the SC5000 to the VV703 last year. Didn't realize it until this year as we have been running the genny a lot in this heat. My fuel gauges on the VV are correct and read accordingly. The issue I cannot figure out...
Has anyone changed out the 2 speaker (woofer/tweeter) to a single speaker in their arch? If so, what did you do with the left over tweeter speaker holes?
Thanks, K
We just upgraded our stereo head, primary amp for the cockpit and speakers in our 2006 340.
The amp had an issue, it was an aftermarket automobile amp installed by the PO, so we changed out the entire system so we could get LED spkrs.
I have the Clarion Head Unit CMD4 along with the CD...
Had a neighbor who bought his first boat to seasons ago. Boat was surveyed by a surveyor that was recommended by the seller. No broker involved. Yes, I know - 2 big mistakes, especially since he was a first time buyer. There were several things we found after he purchased the boat as he...
I have a TTop Brand Marine Boat Cover for sale. It is 5.5' X 7.5' and stretches. Comes with 2 extendable poles that fit into rod holders. The front end straps (with buckles) to an existing Bimini support and there are rail clip to secure the middle. See pictures below. The one is one our...
Anyone have any luck with cleaning or reconditioning (painting?) the windlass foot switch covers? Tried about everything I can think of. Just cannot seem to get them clean.
So this years project is to add a full camper canvas to our 2006 340. Since there is not a template from Sea Ray as this was never an option, we are going the Custom route. If any 340 owners or past owners out there have an pics or suggestions as we are in the designing stage, any and all...
Working on upgrading my SC5000 to Vessel View, 06 340. Which unit are most upgrading to, the 703 or 903 (will the 903 fit where the SC5000 currently is ) ?
Looking at the specs it looks like it may, but is certainly a tight fit. Anyone done this?
Thanks, Korkie
Just received my Geico Insurance renewal. $222.00 increase from last year. Have had no claims, no citations, no incidents what so ever since started boating 43 years ago. Boat moored at same place. Just can't figure why. Geico says it is due to increased labor rates and claims in my area...
Need to have some of my bottom sections of my cockpit seats recovered (broken stitches, seams, etc). Wanting to match original as close as can. Any recommendations in or around the Annapolis area? Thanks, K
Looking for some diagnostic input. 2006 5E Genny in 340 will start and run fine before leaving dock. It will run for as long as 2 hours and not even hiccup. Leave dock and run up on plain for 15 min or so and it will either shut down while running or shortly after mooring. When attempting...
We have a Custom made Mattress for forward birth 6" therapeutic 34 Sundancer. In like new condition. We have a water bed at home and the wife bought us (for my Birthday) a custom water mattress that is just like our home bed. It was quite pricey, but soooo comfy. It is 2 pieces just like...
Looking to install an engine room camera to view via my Garmin 7612. Anyone have a setup for a day/night vision system in place using the 7612?
Thanks, K
Been having some intermittent power issues. ie. Brief loss of power to Smartcraft system and port motor. Like turning switch off and back on. Also some issues with brief loss of rpms on stbd motor. Pretty much ruled out fuel issue, still plan on putting pressure gauge on fuel rail to verify...