Search results

Yea, I’m not a small guy (5’ 10” 230lbs), I fit fine.

Not many have more horsepower then mine, I have 6000 miles on it and no issues with that rear end, all the Backdraft forums I am on never heard anyone have an issue... But I LOVE your 32’ on my short list! I am in the process of building a 61’ Corvette resotomod using a LT5 motor.

This is my Backdraft Cobra, this is a factory built (not a kit) Cobra with a Roush 427 (550hp / 535ftlbs), I can raise the front wheels off the ground hitting 2nd gear! It’s just a little fun.... ;)

Scott, been watching from the side lines, seems things are going in the right direction!! Now get back up in the air!

Glad to hear you are recovering well my kidney cancer brother from another Mother!!

Congratulations Brian!!

It’s all basically fast except when passing some marinas, definitely some skinny water but it’s OK.

I have used these guy’s: https://www.promarengine.com/

Check out this place, I have bought from them chain a few times, this is free shipping, 200ft of 5/16” G4 HT Galv $659.00 https://www.marinenow.com/5-16-iso-g43-high-test-marine-anchor-chain-144-m-micron-thick-hot-dipped-galvanized-nacm/

I bought the equivalent of model number 297.5. There were many cracks in the hose when we removed the old one.

I believe it was me... I changed to a Centex muffler (double the size of original lift type). And at the same time I replaced both sides of the 2” exhaust hose and all new hose clamps. This reduced exterior sound level about 30% (per my dB meter). I believe I posted at some point the actual...

I started out with a complete mess, over the years of adding electronics, then installed the Blue Seas 12 circuit fuse block with grounds

Check it out, very cool!

Earlier on in the video I saw a clip of your Port tech and it was indicating 2600 RPM but you where only running about 21-22kts (per your Axiom screen)? Is that tach inop? You should be a lot faster at that RPM...

I live in NJ, we can’t carry here, so I have no carry permit (unfortunately). But I travel through many states on my boat as we travel on the East coast, so it would be hard to carry anyway. But what we do have onboard is a “non lethal” gun that shoots a high powered pepper ball. This way I...

Yes, the hoses are 2”, but found many cracks in the hoses so I replace both sides along with new hose clamps. Not sure what you mean about the rubber washer? I bought all the material but did have my very skinny mechanic climb back there and do it all. I know he told me the tail pipe that comes...

I did, It reduced the sound by 30-40% https://www.marinepartssource.com/2-side-in-top-out-fiberglass-muffler-centek-1500027 Change your hoses and clamps!

Dam! I didn’t even think of them! And I literally just received an order from them yesterday!! Great call!!

I looked on Quikserve too, problem is its not just a 6CTA sending unit, its different due to the dash gauge from Sea Ray. Has to be specific to the gauge..

They are the mechanical 450C