I have 7 12 ft sections of 1.5 inch stainless steel rubrail. These are brand new and retail for 280.00 each plus shipping from taco marine. Asking 1000.00
https://tacomarine.com/rub-rail-store-stainless-steel-s11-4690p12
One of the reasons we went with the express. So much room for activities lol. Here are the lights I used. Yes ignition protected.
https://www.lumiteclighting.com/nevislt-led-utility-light.html
You are correct. These are the underwater exhaust pipes that go through the hull after the mufflers. Pictures are without the bronze elbows attached. It is possible that if the hull were cored it would have most likely soaked into the coring. My hull us 100% fiberglass on the hull bottom so no...
Repaired the underwater exhaust tubes before launch this year. I have been trying to track down water in the bilge and finally discovered it was coming from the exhaust where it is attached to the hull. Before and after pics attached.
They are Hella Marine 980620911. If you want a set I can sell you a set and drop ship them to you. I own a marine electronics company. Lakeeriemarineelectronics.com
Power is typically the middle. Power out to the network on the bottom. Ground to top post to illuminate the switch when on. If you have the standard Carling sptp switch.
They are powered by the nmea2000 network. Does your boat have one already installed? Fox does recommend switching them on after the engines are started. So your nmea network power should be connected to a switch.