Had bottom stripped and painted with Pettit Odesey 60 last spring. Now just need to touch up stern chine area. A quart sill be more than enough but every source I check only have it by the gallon which I have no desire to store. Has anyone found a supplier that stocks quarts or is there a...
Anyone know the correct way to test a selinoid like this one that controls the bow thruster? Terminal A goes to load, terminal B goes to Bat. Terminal 1 is marked btown/grey, terminal 2 is marked white/purple.
The one pictured is bad. I only found out because a dockmate could hear it click but...
One of the main lift rams has a bad seal. Hauling the boat for weeks in season is not an option. Wondering if there is anyplace that can send rebuilt rams with core exchange, then I send my old ram in. Repair could then be done in a day.
GHS is not answering the phone so they sadly are not a...
Having all bottom paint stripped off. Will be getting two coats Pettit Trinidad. I have read of using a different first coat color so it shows through the top coat as it wears. Do many people actually do it that way. I don't see many examples in the yard. Pros and cons?
Thank you in advance.
It has been mentioned that OSI QUAD MAX in black does well as a windshield sealant. However no one including amazon has it stocked. I can only find OSI QUAD, not maxi, at Lowes and it does not list glass as a bonbable surface. I have used Dow 795 on framless ports and wonder if that might be a...
Ok guys I took one for the team and cut out the transom trunk floor to explore getting access to the steering gear. Hopefully the pics will attach.
What I found good and bad..
The floor is about 3 inches thick, 3/4 plywood, 2 inches of foam sandwiched around a layer of hard rubber. Like they...
Has anyone had experience with marinco eel power cords? I need to replace one of my power cords and have read the eel cords have a larger diameter head. I wonder if there are issues fitting it through the cord port on the transom. Would not be good if the plug did not feed through the opening...
Hello all.
Last year was our first spring commissioning. I changed to aluminun anodes on the hull and swimplatform gear. The props shafts rudders and swimplatform lift arms were well coated in zinc paint.
In the fall the aluminum anodes were way wasted by over 40 percent or more. I did not...
We are told fuel costs have lowered a little bit and they look like they have at the gas station but not at the marina! Our monthy news letter from Haven Harbor in Rock Hall where prices are usually about average or better lists diesel at 7.06 and gas at 5.32. These are off season prices and...
Went down to boat to disconnect the batteries for the winter. The two new group 27s were down to 12.57v but the two older 27s were down to 3.8v. I quess the pumps were running after she was hauled and the AC powered chargers were disconnected.
My question is should I worry about the 3.8v...
Have decided on Corinthian Aquamat vinyl flooring for the cockpit in our 400 Sedan Bridge. The cockpit has one hatch in the middle which should be a separate piece from the rest. Should we try this ourselves or hire it out? We found a person in our area who was recommend but she has been very...
Need some help diagnosing the non functioning vetus bow thruster in our 400 sedan bridge.
Unit doesn't function, green light on joystick control does not light when master switch on the bridge is on.
1. Checked batteries one was 12.4 volts the other 11. Replaced both.
2. Checked continuity of...
Having problems with GHS swimplatform. Call their 855 791 0128 number and get wierd message, I leave a call back number that does not get returned.
Last week platform started to lower very unevenly so I immediately retracted it. Afterwards did not operate at all.
Just added 24 oz of fluid to...
My 400 Sedan bridge has an extended hydraulic swimplatform that extends about four feet. Often times it is awash with water splashing up and forward over it as the picture shows. Is this normal or cause for concern? Once up on a steady plan it is up out of the backwash.
Often my old vintage 99 Raymarine chartplotter blanks out sections of the display. It will change with any zoom in or out. There is a slot for a C card but I don't think there is a card in there.
Anyone know the reason? Please no Garmin is better debate. The old Raymarine is what I have and...
Just installed a 9hv Raymarine Element gps. It came with a Navionics card. Setup was smooth but after adding homeport as a waypoint and pressing goto, it just plots an as the crow flies straight line course. My tablet Navionics plots a functional course.
At set up I saw a need a Navionics...