cummins alarm "132 sensor throt low ' what does this mean ? leaving so need advice

[indecision]

twice , when i turn my ignition on this alarm comes on and in about 5 seconds goes off . this all before i actually start the engines . the history says it has occurred once on startboard and once on port . getting ready to leave on a trip and is this an issue to be addressed thanks for any ideas !

 

[fwebster]

Re: cummins alarm "132 sensor throt low ' what does this mean ? leaving so need ad

Cummins explanation on their spec sheets says:

Accelerator Pedal or Lever Position Sensor 1 Circuit
Voltage Below Normal, or Shorted to Low Source

 

[indecision]

Re: cummins alarm "132 sensor throt low ' what does this mean ? leaving so need ad

thank you for the reply ,! any idea if i should get cummins up to resolve right away or ??

 

[fwebster]

Re: cummins alarm "132 sensor throt low ' what does this mean ? leaving so need ad

You have electronic throttle controls and the Cummins system is sensing low voltage at the sensor that detects the throttle position. You may have a problem with the sensor or it may be with the throttle control itself. The sensor may not leave you stranded, but a bad throttle control could mean you come home in guardian mode....real slow. The challenge here may be in who supplied the control to Sea Ray. If it were part of the engine package, then Cummins is the right call, but if the throttle control was provided by Mercruiser, then your Sea Ray dealer may the the right call. I would call Cummins and tell them your fault code and ask them if they or Mercruiser is the right repair source.

Good luck with it.........

 

[indecision]

Re: cummins alarm "132 sensor throt low ' what does this mean ? leaving so need ad

good ideas , i was going to check water in my batteries , could that be it ?

 

[indecision]

Re: cummins alarm "132 sensor throt low ' what does this mean ? leaving so need ad

found out that this alarm can occur and if you do not "clear it smart craft " it can keep alarming . cleared it , has been good since fyi

 

[hbishop3]

Re: cummins alarm "132 sensor throt low ' what does this mean ? leaving so need ad

How do you 'clear it smart craft'? I have the same problem every time I start and it takes forever to get my engines started...

 

[hbishop3]

Re: cummins alarm "132 sensor throt low ' what does this mean ? leaving so need ad

Is there a button to clear it?

 

[Arnold]

Hi I have the same. How to clean the actual error in Smartcraft? And what could be the fault, bad sensor?