Gadgetry

Discussion in 'Diesel Engines/Drives/Transmissions/Props' started by jmcdboater, Oct 9, 2022.

  1. jmcdboater

    jmcdboater Active Member

    323
    May 28, 2022
    Stockton, CA
    1988 300 DA Sundancer
    Vessel JIM’N’I IV
    Twin 5.7L Mercs w/Alpha One Drives
    Koehler KVA 4 Genset
    Question for the group….so a Mechanic is on the boat, mains rumbling in idle, one of the tacks is reading 600-700, right where I want it. The other tach is reading 1000-1100, but the engine does not sound any different(faster idle) and the synchronizer is reading 12 o’clock…dead even. So the mechanic whips out a small gadget, walkie-talkie sized, with an pull-out antennae, and says….”yep dead on, 650 rpms”.
    So two things…..obviously I have a bad tach, and what was the thing he had (I didn’t even think to ask him, duuuuh), I want one!
     
  2. Stee6043

    Stee6043 Well-Known Member

    Jun 1, 2015
    West Michigan
    1997 Sundancer 400
    7.4L Gassers
    You may not have a bad tach - it might just need a little love. Some folks can resolve this issue by simply pulling the tach, switch the "cylinder select" selector back and for a few times. Reinstall and see if that does the trick.
     
    jmcdboater and Nepenthe like this.
  3. The Bill Collector

    The Bill Collector Well-Known Member GOLD Sponsor

    Jun 2, 2008
    Tacoma, WA
    1998 450 Sundancer, Achilles dinghy w/15hp
    3126 Cat's
    Above and also pull the wires off, emery board the connections, apply dielectric grease and reinstall. I have done this successfully...
     
    jmcdboater and Mauler34Rod like this.
  4. Phil S

    Phil S Well-Known Member

    Oct 16, 2020
    Taxachusetts
    Former 2004 300DA
    5.0 MPIs and Bravo IIIs
    New boat incoming
    Sundolphin 9-foot Tender
    9.9hp Mercury OB
    No one has any ideas on the gadget ?????

    I wonder if that's some kinda novelty thing. I want one!!!!

    Then when the wife says: I think the ___________ is acting up. You pull out the box, adjust the antenna, push a few buttons, then go "no it's fine"
     
    Mjresq4 likes this.
  5. jmcdboater

    jmcdboater Active Member

    323
    May 28, 2022
    Stockton, CA
    1988 300 DA Sundancer
    Vessel JIM’N’I IV
    Twin 5.7L Mercs w/Alpha One Drives
    Koehler KVA 4 Genset
    Maybe I’ll need to call the mechanic back and ask him, a little walkie-talkie sized gadget to read rpm’s….I imagine it was reading the the cycling of the distributor??? I would like to have one……who knows what it is???
     
  6. The Bill Collector

    The Bill Collector Well-Known Member GOLD Sponsor

    Jun 2, 2008
    Tacoma, WA
    1998 450 Sundancer, Achilles dinghy w/15hp
    3126 Cat's

Share This Page

Show Sidebar