Warning message wheel end stop disabled helm 1 starboard engine

Discussion in 'Pod Drives' started by Captain Trey, Oct 3, 2022.

  1. Captain Trey

    Captain Trey New Member

    4
    Feb 15, 2022
    2015 Sea Ray 470 Sundancer
    Twin Zeus QSB 6.7 480HO Diesels POD Drives
    Everything was fine prior to the hurricane coming through. After the hurricane I have hydraulic fluid leaking around my starboard engine with this warning message.
    "Warning message wheel end stop disabled helm 1"
    The tide went very low. May have sat in the mud during the storm.

    Ideas??
     
  2. hottoddie

    hottoddie Well-Known Member

    Jan 11, 2012
    Boston/Cape Cod
    1986 Sea Ray 390 EC
    Garmin 4212 Chartplotter
    Garmin 24 HD Radar
    Garmin 546s Plotter
    454 Crusaders
    I think there is thread dedicated to Sea Rays with Zeus drives.
     
  3. Shaps

    Shaps Well-Known Member GOLD Sponsor

    Nov 4, 2019
    Long Island,NY
    2010 Sundancer 500
    2015 Brig Falcon 330T
    Twin Cummins QSC550 DTS w Zeus
    First question I have is what are the condition of your batteries?
    The sensors are known to be voltage sensitive.
    Once you are confident in the condition of both batteries I would try to reset via all keys off and then key on to restore steering wheel self‑centering and to attempt to erase fault code.

    You are in the pod specific part of the forum
     
  4. Spark600

    Spark600 Well-Known Member

    399
    Dec 28, 2013
    South Shore Long Island NY
    2015 Sundancer 410
    Onan Generator
    Mercury dinghy
    Cummins QSB HO 380 HP
    Zeus Pods
    I got this message once when the engens were keyed on and not running.
    I turned on the keys ( Key on ) and then touch the joy stick without the engines running and got the message.

    To clear the message I turned off ALL power to the motors ( Computer ) My mechanic ( Pod Guy ) told me to do a hard start on the computer.
    Not sure about the oil without see it.
    I would have someone start the motors and turn the joy stick when I am in the engen room looking around for the leak.
    I would check the valve body on the back of the pod, my friends leaked there.
     
  5. Captain Trey

    Captain Trey New Member

    4
    Feb 15, 2022
    2015 Sea Ray 470 Sundancer
    Twin Zeus QSB 6.7 480HO Diesels POD Drives
    Thanks for the information. All batteries were dead due to a stuck float switch and a hurricane. Everything is changing up now but I have the code. I'll try a reset and look for a leak as recommended. Thanks again
     
  6. Dunigan

    Dunigan Member

    53
    Nov 21, 2018
    2013 Sabre 42
    twin cummins qsb 6.7
    If water got into the pod bay, check all connections on the pods to make sure no water has gotten into them, especially the steering connections on the actuator manifold.
     

Share This Page

Show Sidebar