Recent content by 2005-Sundancer300

That's an intriguing thought - however, there is a full storage cover over it and I always remove the drain plug after each use as well...

And you're right - when I was a kid, we used to throw in the lake an old Larson cedar strip boat, let it fill up and sink in shallow water, wait for the wood to swell and bail it out and go!

Ok, thanks Brad for the posting tip - I'm pretty new - and not sure how this all works...

Hello SeaRay Nation! I am posting this on a few forums within ClubSearay.com - so if you see this more than once, pardon me in advance... Anyway; here's my situation: on my 2005 300 Sundancer (w/twin 6.2's and B3 outdrives) - every time (for about the past 2 years) we launch this baby (we...

Hello SeaRay Nation! I am posting this on a few forums within ClubSearay.com - so if you see this more than once, pardon me in advance... Anyway; here's my situation: on my 2005 300 Sundancer (w/twin 6.2's and B3 outdrives) - every time (for about the past 2 years) we launch this baby (we...

Hello SeaRay Nation! I am posting this on a few forums within ClubSearay.com - so if you see this more than once, pardon me in advance... Anyway; here's my situation: on my 2005 300 Sundancer (w/twin 6.2's and B3 outdrives) - every time (for about the past 2 years) we launch this baby (we...

Hello SeaRay Nation! I am posting this on a few forums within ClubSearay.com - so if you see this more than once, pardon me in advance... Anyway; here's my situation: on my 2005 300 Sundancer (w/twin 6.2's and B3 outdrives) - every time (for about the past 2 years) we launch this baby (we...

No Zoomie - I run with 4 of them (lead/acid) and have no problem with any residue or film - but they're in a pretty large bilge area with plenty of air exchange. That (residue/film) may only be a problem if they were in a small confined area that lacks such air exchange... Good luck.

That's really awesome Jim - I'll keep an eye out for them and let you know the results! Thank you!

If you have the vacuflush book, it should tell you (or at least a part number). Also you want to know if you have 1 on each side of the pump - or 2 of these valves on each side of the pump - depending on the style of system you have... Good luck, real fun job :-).

No, I don't believe that was me. But thanks for the messaging tip! I saw that option but thought it was referring to a starting a "public conversation" - but apparently not...

Not sure how to do the messaging thing without an email or phone number - so here's my info: Mike Pote PO Box 4096 Grand Junction, CO 81502. Very much appreciated - next time we go out on our boat I'll install these little "jems" and let you know! Thank you!

Hi Jim, Since I'm new to this forum; what's the best way to send you my address - just post it here? Thanks!

Hi Jim! I'm a new member, but a lifetime of Searay's! Anyway, I know it's been a while since this post, but if by chance you still have 4 of those transistors left; could you send them my way?? From everything I've read, they should do the trick! Thanks!