Recent content by 500oasis

Hope everyone is well . The lower pull out portion of my salon couch no longer latch to stay in when not pulled out. Does anyone know where the latch is located to hold it in ?

Thanks Grant ! 40k is about the quote I got and like you said just doesn’t make sense . H3O plus it is .

Grant, if memory serves me correct you have a Hurley H3O plus davit for your dinghy. If so do you recommend it ? I priced making platform hydraulic, cost prohibitive. Any feedback appreciated. Thanks

That makes sense !! The quote I had gotten was $ 9000.00 installed! I will look at the system you are talking about , my issue would be getting it to New Jersey

Thanks Grant, I will look back at threads. I checked into teak also, and at some point will do it. One thing that concerned me as I looked at prior teak install was they covered the seem in the floor that you would have to cut out if you needed to lift or remove the rear floor for an engine for...

Grant,your interior looks incredible! The diamond pattern really looks perfect ! Can I ask what the lower cockpit floor is ? Thanks again for all the research and improvements you share ! Happy New Year

Tucker boy , I did a camper . If this photo actually posts I will take more and post them.

Shaps, good luck with the new install I'm sure it will come out great. If you haven't disposed of the old fridge I would like to buy the freezer door from you as my latch is acting up . Let me know. Thanks

Thanks to Shaps and JB for the info . Struts ordered and on the way.

Has anyone replaced gas struts that hold up rear compartment door ? If so please share info. Thanks

Shaps,Thanks for scans .As I find out how to read them I'll let you know .Once I get in water I'll get some speed and RPM numbers so we can compare .

Thanks Shaps, much appreciated . I had shafts ceramiced and will keep you posted . The place turned them around quickly and the entire process seems very straight forward . if you decide to do yours in the off season I gladly tell you all the things I've learned .Thanks again .

Shaps, if you have any scans or info from prop rework I would appreciate any guidance you could provide . Looks like your boat was FLYING . I don't want to be left in your wake !! Lol

My guys take apart and reassemble , we are sending shafts to Flamespray Northwest . This is the guy that machines and powder coats area that seals run on. If you like I will send you before and after photos . Text me 973-418-0448 I haven't got the posting photos down yet.

Minor water intrusion on one lower unit . Shafts are grooved so I'm going to ceramic coat them and while everything is apart new bearings and seals then all should be good . JT down in Somers Point is a friend of a good friend of mine . Spoke with him at lenght as he did his years ago . I'll...