Recent content by CaptainSandBar

I’m looking to install new cockpit carpet for my 07 340 Sundancer. Any suggestions on which site to use? thanks!

Update*** Found the leak. I replayed everything I do on the weekend, including connecting to dock water. I pulled out the fridge yet again (thanks Kevin for the suggestion), used a brighter flashlight, and found a small canal of water, traced it to the galley cold water Pex piping. Small...

There is a small amount of water behind shower sump. I ran the head faucet into the shower drain, the water was visibly going into the sump and pump operated fine. I’m going to remove the kick plate wall below the head door and take a look. I’ll keep you posted. I am in Massapequa

Thank you for the suggestion, we don’t use the coffee maker though. I use a k cup up in the cockpit.

All 5 of us shower in the boat so if it was leaking that certainly could be the culprit. I’ll take a look later today. Thanks!

Just took out the drawers and fridge. Ran galley sink for a few minutes, no visible leaks and carpet behind drawers and bulkhead were dry. Drain junction and thru hull dry as well. The wettest area is immediately outside head door at bottom of stairs. I feel as if the water spread forward and...

Thanks Kevin, I’ll give that a try today. Keep you posted.

Hi All, I have an 07 340 sundancer. Over the last few weekends my cabin carpet has been getting progressively soaked as the weekend progresses. Specifically from the fridge then aft to under the stairs. Dry when we arrive at our weekend dockage, no rain etc.. so it is not an outside rain / port...

I posted a thread re: Trim Fault. After taking in the feedback I now have realized that my drives or not trimming at all. No movement / no soundwhen I press the trigger on the throttle up or down, or when I use the trailer switch. Fuse? Bad Switch? Any feedback is appreciated. 2004 280...

Thank you for the feedback, I'll take a look when I haul it out.

I have a 04' 280 Sundancer with twin 4.3 lt Alpha I's. I am getting a "Fault Trim" msg at start up on my Port Gauge. My drives don't seem to be moving u/down when I use the trim button on my throttle (I don't hear them move). Any suggestions on trouble shooting is appreciated. Thanks-