Recent content by DGAM

With these Starboard engine compression test numbers.... what should I do??? .. the motor start hard when warm.. but if you goose the throttle a few times it does start and runs well. I have about 1300 hours on these Merc 7.4 Horizons 2001 vintage! 2 165 4 124 6 145 8 120 1 105 3 159 5 150 7 160

ok found bad water pump replaced still can't find leak coming from bath room area into center compartment

With fresh water hose connected from shore all water systems work fine. When using holding tank water (full) i get no pressure , no water service anywhere and leak in center compartment 45 angle top left corner dripping appears to be coming from head sink shower direction leak is forward of...

Anyone do this>

$2,500-3,000 in labor only to completely remove the transmission from the boat without cutting anything and reinstall it.

Has anyone had issues with the rule rm2000?

Anyone had the windshield vent stop working? Checked breaker - Breaker ok., Switch tested ok What could i check next?

anyone silence the vibrating cockpit refrigerator creatively? Apparently the frig doesn't sit on its feet rather is suspended in the cut out opening via the 4 screws / flange was thinking to either add plywood to raise support under unit or wedge with shims to stop vibrating

if you have one e120 already and one navigator , all running off ray marine network what all has to be done to replace navigator with an e120 display to = 2 e120s

anyone selling polk momo speakers they upgraded please PM me

Does the pd2050 work with agm batteries?

so the 2050 will not work with AGM>

bump what happened did you get the CDM5 to work where the cdm4 was?

That thread is 20 pages long - what was the problem - was it a torsional coupler?

how long does the job take to replace the torsional coupler? who did yours? please do share need the job done asap