Recent content by eddie

Greig Electronics 609-384-3395

Thanks so much!

KevinC,did you replace the serpentine belts as well? Looking for that p\n. Thanks,Eddie

Looking for a replacement for the cockpit faucet on my 2006 340 sundancer. Any tip would be appreciated. Went to 6 plumbing places by me and no one had anything.

I got this one . When you cut the wires to install the monitor,the relay may pop on the electrical panel. https://www.westmarine.com/buy/fireboy-xintex--co-carbon-monoxide-detector--18771725?recordNum=3

STEELE RUBBER PODUCTS

Wowwee! That's great. I did get a panel custom cut from technographics for my gps and I do have smartcraft. I would still be able to use that for depth,correct and will the gateway be able to send all info to my garmin mfd?

Thanks again. I have a Garmin 8610xsv and 18" Fantom radar that I want to install, but might have it professionally installed because of trying to tie in the engine data. Don't really have a clue about backbones, neckbones and the like. I have put in amps,subwoofers and speakers with no problem...

One more question,Kevin. How do you remove the cockpit seat back cushion?

Thanks so much.

How hard is it to run the cable for the new Garmin 18" Fantom radar on the arch? Was told that some of the aft cabin had to come apart to get to the firewall to drill a hole.

Thank you so much.

Looking to do the same on my boat. What size boat hooks and sail shade? Thanks,Eddie

Hey Gator, I'm still waiting on any pics of your setup. Thanks,Eddie

Thanks for the reply. Pics would be awesome! And if you could ,transducer model # and if it all works with Smartcraft for engine data. Thank you so much.