Hi There.
I'm a relatively new member here. I've been around the block however when it comes to boaters or boating I still believe in the comradery, honesty and the feeling of belonging to a special group of fellow boaters. In any event, I assume you being a super moderator that you have the...
I got scammed on this radar. Don't make the same mistake . It wasn't Steven K . Some other guy jumped in on the lead Message me if someone else contacted you. Hard to believe there are thieves on this site.
I'm looking to replace the piece of upholstery that goes around the entrance way. It the piece that's about 3 or so inches wide there and has the piping on the top. The wood on the starboard side got wet and I was wondering if it's cheaper to custom make it or is this a part Searay would have ...
I found the motor. I didn't realize the blower works for the forward head and the Galley. It was getting power to it so I guess after 20 years the motor is blown. $60 bucs lol. Thank you guys
I just bought this boat recently from a friend and there are some problems I just can't figure out easily. All of the vents did work (Galley and 2 heads) then all of a sudden none work) That seems weird . I know there is a circuit breaker on the main panel for vents however I was wondering if...
So I need to order a new tides unit for 1 side. It is a Fsk1750-3500-1. I know the blue hose is bigger in one side. Do you happen to know the the big side. Is it 3 1/2 "? Im pretty sure it is however I can't see any numbers on the old one.
That's good to know. I had a feeling I wouldn't have to remove the rudders but I was hoping I wouldn't have to remove the shaft. And yes there will be an extra one or 2 seals on this shaft . Just in case
Thank You
Why did you go with Lasdrop? Was it the price? I think they are quite a bit less if I'm not mistaken. Or do you think they are better for some reason ? The port engine has a spare seal on the shaft. I'm gonna take a close look but I may be ok just using the spare. Lot easier anyway. Yes this is...
Thanx for the input. I was hoping not to have to remove the props but so be it. I do have V Drives. That is a big issue I found . No room down there. I'lll look into those Lasdrop but I think I may be better off to stay with the same thing. I guess I'll figure it out