Recent content by Lhs3422

Getting ready to replace my icemaker with a new fridge under the helm seat. Pulled the original Uline and it seems like a pretty tight space for what I'm seeing from the usual manufacturers (Novakool, Isotherm, Vitrofrigio). Any tips on a model that works and challenges with making it fit? Thanks!

Guys: I am changing out the Uline icemaker to a fridge on my '99 370EC. Boat was new to me last year. Freezer fires up and my service records show that Colony replaced it (or at least the compressor) in 2015. Icemaking unit didn't work and is out of it. Opening for it is 14.5"x18". If anyone...

I also read it this way. For me, half the fun is taking a well cared for used boat and bringing it up from there to make it mine. Now I am a Great Lakes guy, so nice used ones can be found. My last boat, a 28 Bertram FBC was 20 years old when I brought it up from Lake Erie and a much better 37...

Great! Thanks again

One more question. Stripped the old stuff out today (a mess!). The center section, just below the vent seems a bit smaller. Did this section take the same size trim? Thanks!

Thanks! I appreciate the tip!

West, I have a ‘99 with the dried out foam windshield screw cover trim. How did your new stuff turn out? This is on my winter list. Thanks

My boat was never on Lake Michigan. First 5 years on Lake Erie, then the last 17 on Lake St Clair with the owner I purchased from. Doesn't mean there is not some past damage. I am going to watch when the boat is splashed tomorrow to see if there's a difference between the port and starboard side...

A different topic that I haven't seen covered in the 370EC conversations. Did a short haul this week at my long-time boatyard for some bottom work prior to going inside for the winter. The guys called me after lifting the boat to tell me they saw some flexing of the gunnels at the forward...

I'll take a look. Thank you!

I am considering the same install for the TV. How did you guys run your power cord? Thanks!

Got it figured out and you were correct . After a couple combinations didn't work, switched to the gray leads and the cockpit and sub fired up and I could control the volume, balance and fade. Thank you for the insights.

Got it figured out. Everything is working. The original head unit and amplifier had combined channels splitting on the input side of the amp. Had to experiment with a couple combinations using the RCA outputs from the new head unit. Thank you for the insights.

Vince: What I have is the original Clarion under the sink. Got a couple ideas and will report back. Thanks!

Actually there are 4 sets, front, rear, "2-zone" and sub. The only one used in the old unit was the sub. I have some RCA's coming tomorrow. Will hook things up and report back. Thank you!