Hello~
I recently purchased a used radar arch for my 268. It's a little rough and will need some repair. I would like to paint it with urethane paint. How can I find the correct color? I already contacted Sea Ray. They said their records don't go back that far. If I take the transom door or...
I just replaced the Mercruiser 454 engine in my Sea Ray 268. Before I put it in the water I wanted to add a cooling system. I have a heat exchanger from a Crusader 454 engine (part number 97930).
Can I make that work for my application?
Hello all-
My carbureted 454 I’m my 1988 268 needs to be replaced. The po had it replaced in 1996. I’m not quite sure what generation it is, other than it has a mechanical fuel pump.
I found a low hour 454 MPI. Other than an electric fuel pump, will this be a “plug and play” type of install, or...
I thought I would post this request in the local area. My 268 Sundancer's 454 engine is now toast. The short story is the block is no good as it ingested a lot of saltwater. However the components are still in good condition. So. I am in search of a replacement 454 long block. I live in the...
Thank you for your comment. That is what I am looking into. I'm now trying to find a local facility that sell now or rebuilt long blocks. You're right, the components on this engine are newer and in good condition.
Thanks for the comment. I don't know if water got into the cylinders. I also inspected the exhaust flappers at the beginning of the season, and they were good.
Thank for your input. Boat come out today....I hope! Then, I can remove plugs, change oil. To answer your question. The manifolds and risers are 5 years old. Complete tune-up every spring (plugs, filters, oil, wires cap/rotor, Seafoam)Thermostat replaced spring from 2019, and I change the water...
I have a 1988 Sundancer with a Merc 454. It has run great all season. Today, we took the boat out with some friends for a boat ride. The boat ran well up the river, then when we got to open water I pushed on the throttle, the engine started to climb up in rpms and then the temp alarm went off...