Recent content by SRMark

Thanks!

I ordered the chemicals to make the powder for the first time. Does it matter if you mix it all at once or do you have to mix it in small batches as you use it?

That looks great. Mine has 3 large hazy areas on the top. I will look at their website. Thanks

How did you apply the epoxy and what was the product?

Have you checked Flounder Pounder? I recall seeing the posts on their site.

Thank you.

My oil guage on the dash is bouncing around while under way. I called the local Cummins dealer and they told me the part number is 3897170 for the oil transducer but is is out of stock and he didn't know when it would be available. Mine has the single wire. Has anyone found a source or a...

Does anyone know what years the hardtop was available on 410 Express Cruisers? Was it only available with diesels or with gas engines too?

Looks like the ass man is back in town.

My fresh water pump stopped working yesterday. I have a 2004 420 Sundancer. The pump I have is a Shurflo 3.5 GPM that says it supplies 40 PSI. The closest one I see is a Shurflo 4.0 that supplies 55 PSI. Has anyone installed one of these or is that too much pressure for the fresh water system?

How much for the table and base?

I had no idea what a NMEA 2000 backbone was when I did mine either. I contacted BOE marine electronics where I had purchased the Garmin. The NMEA 2000 backbone is a series of connector tees that will allow you to connect older components that are NMEA0183 to your new unit. Emily at BOE was very...

I replaced the Sea Ray Navigator with the Garmin 1243xsv on my boat last fall. I had to install a NEMA2000 backbone into the Garmin and connect the transducer to that. My boat is a 2004 and had an Airmar d17 transducer that I replaced with a DTS800. Search transducer in the electronics Q&A and...

I read that she and her wife are going to work to get all the "wrongfully detained" people free. Kinda like OJ Simpson vowing to find his wife's "real killer".

I have a 2004 420 Sundancer with 6CTAs. Did an end of season oil change and sent samples for analysis as usual. Starboard engine had high fuel in oil, 5%. Previous years it was always .5%. Port engine was at 1%, previously always at .5% also. Boat is now in storage for the winter. Anyone had an...