Recent content by tdheck

Thanks for the information. Similar to you I have the 450DA Sundancer with galley to port. However, I have CAT 3116 engines. Have had the boat for 10 years now. Absolutely love it.

Hi RWS. I have a 1996 450 in which the system monitor failed as well. Searched for months and never found a replacement. Feel confident I can manage engine mechanicals via dash, but don't have a high water alarm. How did you wire these into your system?

Hi all, After almost two years looking, I have not been able to locate a replacement systems monitor for my boat. The only issue I can't independently monitor without the systems monitor is the bilge high water warning. Has anyone installed an aftermarket bilge high water monitoring system...

I'm going to put some PB Blaster on it this weekend and see if I can pry it off. I've have already tried to unsuccessfully pry it off. I'll let you know if it works. I did see one post online that someone used a dremel tool to cut it off. May be my next shot.

I have read that elsewhere as well. The end piece is fixed and does not tilt up. The new wiper replacement has a similar design to what you are mentioning in which there is a cover over the part that connects to the motor exposing the set screws.

Hey all, I'm going to tee this one up again just in case someone here is familiar with it. I originally posted it Friday. Pictures are on the original post. Thanks again in advance if anyone knows what to do here.

Hey all, I'm going to tee this one up again just in case someone here is familiar with it. I originally posted it Friday. Pictures are on the original post. Thanks again in advance if anyone knows what to do here.

Thank you!! This website will prove to be useful for a number of things I'm looking to replace.

BC, can you share what you ended up doing here? I removed the gasket as mine was leaking as well and now I have duct tape over it to keep it from leaking. Not super aesthetically pleasing. Thanks.

Hi all, Hoping you might be able to help me out here. I have a 1996 450DA. I'm assuming based on their condition that the wiper arms have never been replaced. However, I can not for the life of me figure out how to remove the old arms. There are two holes where set screws are supposed to go...

Thanks Frank and JC. I have the part numbers from the original parts manual. i called the Sea Ray dealership in Michigan City Indiana to check availability. The guy said the the part number for the panel monitor was superseded with a new number. The part number for the control module below...

Hi all, i was out on my 1996 450DA when the system monitor lit up like a Christmas tree. All lights went red and the alarm went off. Nothing wrong mechanically with anything on the monitor. I checked everything. Couldn't get the alarm to go off, so when i got it back to the dock I had to...

Thanks for replying. How did you remove the hose from the mid cabin head to the vacuum pump under the floor in the galley? It appears to have support clamps under the shower.

Thanks for the recommendation on the Noflex digester. Just did some research on that. Will try that before replacing the tanks. I do regularly check the gray water sump box. Not a problem right now. Can't believe you have original hose throughout. Just replaced a piece of hose I was...

Hi all. Have that nagging smell in the boat. Have seen a number of posts on this forum about replacing the sanitation hose. Have two questions for those of you who have replaced the sanitation hose on these boats. 1) I took the galley head vacuflush apart this weekend, disconnected the hose...