I have the Plastik swim platform inserts and 4 port light trim rings for a 300 Weekender. All parts are new and free. You pay the shipping. Sold the boat before I could install these.
Midship bilge pump is not working. Check the circuit and there is no power to the float switch. Does anyone know where the power source is for this pump? I would like to backtrack the circuit to see where the problem is. Thanks.
Bought my boat several years ago and just now reworking the waste lines. The guy I bought her from had removed portions of the waste system and installed a live bait tank and pump. I am trying to return the system to "normal". Can any of you fellow Weekender owner send some pics on how your...
I have a 89 300 and the drain is in the same location. Surveyor pointed it out when I bought the boat and suggested running a new line and putting a drain in the starboard side in front of the fuel tank. Hasn't happened yet. Seems like SeaRay would have come up with a better solution.
Dennis,
I believe PO was chasing down a high speed overheat problem that turned out to be risers. He really didn't use the hot water away from 110 from what I understand, so the exchanger was not needed. He left the hoses, but had cut them back a pretty good length. Sorry about hot and cold...
Scorpio, Thanks for the reply. Sounds like that should work. I'm in and out of salt water her so I think I'll give it shot.
Dan, Pics would be great.
Thanks,
Bob
I have a 1989 300 Weekender, 7.4l raw water cooled. The PO replaced all the engine hoses on the port engine. When he did, he did not reconnect the exchange lines for the hot water heater. Does anyone know where to connect the hot and cold lines to the engine, maybe a schematic?
SOUTH ALABAMA DUCK HUNTING
A big city lawyer went duck hunting in South Alabama..
He shot and dropped a duck, but it fell into a farmer's
field on the other side of a fence.
As the lawyer climbed over the fence, an elderly farmer
drove up on his tractor and asked him what he was doing.
The...