Search results

After replacing the starboard transmission and getting it back in the water today, the portside transmission is not fully disengaging into neutral. I can feel it go into neutral, but the shaft continues to spin in the forward direction. Pulled shifter slowly into reverse, about 1/2 say down...

Okay, I give up. How do you access the wiper motor on a 2000 340 Sundancer? Starboard not working, need to get access to see what is wrong. Any help would be greatly appreciated. Thanks Jeff

I received word today that my V-Drive was going to cost more to repair than to buy another. Lots of dilemma’s here. 1st, they have not found where one is available, the manufacture states not available until July:(, but they are still checking with other suppliers or dealers. Ok, the boat is...

Today we took the boat out for the first time. Cruised down to the Inner Harbor in Baltimore, spun around and started heading back. Now I will preface this story as this happened to me last year when I bought the boat and the symptom went away. So, after we spun around and were heading back...

My up switch on the bow is not working. The down switch on the bow works and both up and down from the cockpit works. I took the switch apart today and there is nothing there that can go bad. I assume the Control Box or relay is the culprit. Any help would be appreciated. Jeff

Argh! So here we sit with cabin fever although it is starting to warm up a little, but tonight I went in to check the status of the DC Boat show only to find it has been cancelled once again. They might as well cancel it for good and let Baltimore and Dulles have the shows. I am tired of the let...

I purchased my 340 knowing that the Raymarine RL70CRC Radar display was not working, so I am in the process of repairing or replacing. Anyway, as I was doing a lot of research, I kept seeing or reading about the Seatalk between the other Raymarine items. When I pulled my RL out yesterday, I...

The contrast in my ST60 is toast. I have seen them on Ebay going for 200-300 or more. My question is where can I just get it repaired or is it cheaper to just buy a replacement? Thanks Jeff

I am in need of a new Dash Lower Switch Panel for a 2000 340 DA. Sea Ray apparently does not make them anymore. Any idea where I can find a used one or an aftermarket new one? Thanks,

Well folks, I am selling my beloved 87 300 DA tomorrow to a very nice couple who just loves the boat, so I leave her in good hands. The good news is I am picking up a 2000 340 DA tomorrow and bringing (driving) her back to my Marina on Sunday. Can't wait. She needs a bit of work, but it gives me...

Anyone had any problems with Great Lake responding to emails and phone calls? I have been calling and emailing them for two days now as I am buying a 2000 340 tomorrow which needs canvas bad. Any idea? Maybe they took some time off, just seems odd nobody is returning phone calls or emails...

I am looking for either a set of Eisenglass or an entire Canvas package for a 2000 340. I need this quick. Please email or PM me if you know anyone. Thanks Jeff

I am need of Eisenglass or an entire Canvas Set with slant back for a 2000 340 Sundancer. Can anyone tell me a good and quick source? I posted a WTB add as well. (color is tan) Thanks Jeff

I am looking for either a set of Eisenglass or an entire Canvas package for a 2000 340. I need this quick. Please email or PM me if you know anyone. Thanks Jeff

My old Benson is on borrowed time and I am trying to get it through the summer. I am considering either a Lewmar Pro or a Good Windlass. So, I have a couple questions for those that have made the change. 1. Are you able to use the existing wiring, switches, relays etc with either one? I am...

I have a 1987 300 DA and I cannot find the personnel capacity plaque on the boat anywhere nor can I find the capacity in the owner’s manual. Can anyone tell me what the capacity is and where the plaque is supposed to be located? I think I may have just found my answer. Because it is considered...

I am having issues with my starboard engine shifter sticking going between foward, neutral to reverse. I have had the Marina try and adjust it twice, but it has gotten worse and is now out of sync and neutral is not where it should be. I have looked at the book, seems the problem is the...

Looking for a reasonable priced dock box in the Baltimore or DC area. Wanting 40 x 20 x 20 approximate size. Depending on size and age between 200-300 range. Thanks Jeff

I have a 1987 DA with a Benson Rope only windlass. Does anyone know what size rope it is? I cannot find anything in my books, and I don'a have a specfic Windlass manual Thanks Jeff

Okay so today was engine compartment day as that was the last thing I had to do before I take the boat out for the first time. So as I am going through everything I find two sets wires coming out of each outdrive at the top that are not connected to anything? Both sets (four wires) have...