I don't know if I have a problem or not. Here's the history: boat has been a saltwater boat all of its life until I purchased it last year. First outing this year resulted in a tow back. The port exhaust overheated and burned a hole in the lower rubber exhaust connector. I found that the...
Please see my post (#52) on the following forum if you have any idea where I might locate the stereo speaker wiring connector on my boat:
http://clubsearay.com/showthread.php/1786-Late-90-s-270-Sundancer-Thread
Thanks,
Here's how I installed a (Harbor Freight) 2000 watt inverter in the starboard cockpit storage compartment. There is a small gap next to the hull big enough to pass the wires through. I ran the wires down to the engine. Ground (white wire) to the engine block ground bolt and the positive to the...
The '99 270DA that I recently purchased had a Jasper Bravo 3 put on it right before I bought it because the original Merc Bravo 3 had a failure. I was told by the owner that the drive fluid reservoir alarm sounded and he found outdrive oil all over the engine compartment. I just took this boat...
Has anyone been able to fix a leaky faucet like this one on their boat? I've removed the stems and can't find anything wrong. I've even added O-rings to the gaskets to increase the pressure on the valves to help them to stop leaking and the faucet continues to drip after it's shut off. Can it be...
I normally boat on the Rappahannock and lower Potomac rivers. When terestial broadcast TV was analog, I could watch most Washington and some Richmond TV stations aboard my boat with just a car-type rabbit ear antenna from Radio Shack. Since the switch-over to digital TV, I'm lucky if I can...
My '99 270DA is missing its all-around white light. The parts book says that it's 84 inches long. I can't believe it needs to be 7 feet long! Can someone who has an identical or very similar boat measure the length of their (hopefully) original pole light and possibly snap a picture of the globe...
In the parts manual for the 1999 270 Sundancer/DA, there are references to KX and PX and different parts/part numbers. The best I can tell is that they stand for Knoxville and Phoenix. I assume these are two different assembly plants that this boat could have come from. How can I tell at which...
Just picked up the Sea Ray this past weekend. Boat needs a little TLC but is clean and in great shape otherwise. Will be having fun the next few weeks fixing the little broken things, things that don't work 100% correctly, and tailoring her to our boating needs.
Larry
_____________
Previous...