Looking for a replacement for the cockpit faucet on my 2006 340 sundancer. Any tip would be appreciated. Went to 6 plumbing places by me and no one had anything.
I got this one . When you cut the wires to install the monitor,the relay may pop on the electrical panel.
https://www.westmarine.com/buy/fireboy-xintex--co-carbon-monoxide-detector--18771725?recordNum=3
Wowwee! That's great. I did get a panel custom cut from technographics for my gps and I do have smartcraft. I would still be able to use that for depth,correct and will the gateway be able to send all info to my garmin mfd?
Thanks again. I have a Garmin 8610xsv and 18" Fantom radar that I want to install, but might have it professionally installed because of trying to tie in the engine data. Don't really have a clue about backbones, neckbones and the like. I have put in amps,subwoofers and speakers with no problem...
How hard is it to run the cable for the new Garmin 18" Fantom radar on the arch? Was told that some of the aft cabin had to come apart to get to the firewall to drill a hole.
Thanks for the reply. Pics would be awesome!
And if you could ,transducer model # and if it all works with Smartcraft for engine data.
Thank you so much.
Got a new icom M400BB radio and can't seem to find the old black box. It was too hot outside when I decided to mess with it. Just need the location. The old unit was the NorthStar NS100.
Thanks.
Looks like I may be going the same route as you. Did you have to get a new wood grained face plate or modified the original? Also did you use the old transducer or a new one?
Thanks so much.