So how is the setup now.. I was planning to use the same sensors on a N2K network with Raymarine MFD. What are you doing to digitize your tach's and other analog sensors?
In front of Legal Harborside and Remy's is Liberty Wharf http://www.libertywharf.co/ The going rate is $20/hr. If you go down a little further you can also dock at Fan Pier again for 20$/hr. for boats under 40 ft. http://www.fanpiermarina.com/
So I see you did the searay logo too! Looks sharp. I have a 300 DA that I am looking to have reupholstered. I too would like to have the searay logo stitched in. Did your installer contact SeaRay to get some sort of template?
Sent from my iPad using Tapatalk HD
Just wanted to report back... Looks like reseating the connector on the back of the tach and switching the selector back and forth worked. The tach is now performing as it should.