Search results

I had to replace the timing belt on my Westerbeke 4.5 BCGTC gen in my 1999 340 sundancer. I am going to retorque the heads, adjust the valves and check the timing. My question concerns the timing marks, I marked the one on the crank but do not see before and after top dead center markings on the...

The shower sump and the aft cabin pump on my 1999 340 dancer have no power to them. I looked at the DC wiring schematic in the sea ray owners manual for a fuse or circuit breaker and did not see one ( really small print and bad eyesight with glasses) Has anyone had problems with their sump...

Have to replace my cruisair 12,000BTU ac unit on my 1999 340 sundancer. Looking at a marineair 14,000btu Rev cycle unit as a replacement. Has anyone installed one of these units, and if so, we're you satisfied with it? In order to install the 14000 btu unit I need to know the gallons per...

Have the door for a Norcold DE-541 fridge with almond color insert very good condition..$40.00 Also have for the same unit the power supply and transformer... 40.00. The power supply was working on the unit. The compressor failed.

I have a 1999 340 dancer and my norcold fridge-DE/EV-541 stopped working. Cooling fan for compressor runs when on a/c or D/C. But compressor does not kick on in either mode. Has anyone experienced this problem and what did you do to fix it? Or what can I check to see what the problem is. Also...

Have to change the anti freeze on both 7.4 merc inboards. I cannot find my manuals as to which long life antifreeze I should use and how much I need. Should I use the premixed long life or the one you mix yoursel. Engine is a closed system. Manifolds,spacers and elbows are raw water cooled...

Installed new manifolds, risers and elbows this past June. The elbows and manifolds are merc and the 6" risers are osco. They are mounted on 454 MPI's. While winterizing the motors I noticed rust lines running down the risers on one engine. The line starts at the gasket between the elbow and...

Having problems with a 4.5 BCGTC westerbeke gen. It cranks but won't start. The choke solenoid closes the butterfly but it just cranks. Have spark at distributor and plugs. If I pull the choke linkage by hand it starts right up. I ran it for 4 hrs under a load and had no problems. I removed the...

I have a 1999 340 sundancer. The swim platform needs fiberglass work. I would like to remove it from the stern for it to be repaired. Has anyone attempted this and what problems did they run into? Did searay use 5200 to secure the platform to the stern? Any help would be appriciated.

Joined some time ago but never posted. Computer crashed and some other distractions kept me from partisipatimg So a big HELLO to everyone.