Great day on water. Had a good run home (about 20m). Engines ran great (temps, pressure, etc.). When I came off of plane the starboard engine started to sputter, wouldn't allow throttle, then stalled. Started back up and more of the same. Went and put 50 gallons of new fuel in thinking maybe I...
I thought i had a post elsewhere on this but I can't seem to find it. I have been trying in vein to find the fuse for the bilge. Background, the bilge (either one) work if I pull the float switch. The breaker shows as "on". The button on the dash does nothing. Doesn't light up, etc. I looked and...
Need some help with where I should look.,.. Have an odd stalling problem with both engines. When in neutral and at idle, both (not necessarily at the same time and usually one or the other) engines stall from time to time. They simply just stop running with no reason. They will start back up...
So I put my paddle board on my hardtop a few weeks back and it fits nicely and wasn't so bad putting it up or tacking it down. Anyone actually put mounts (eye strap or bolt) on their hard top (to tie down the toy) and done something similar to transport a kayak or paddle board? I have used foam...
Have some minor items I would like fixed. May do myself but if someone has a good glass person they use, I would love a recommendation. Annapolis, md area
I am sure this has been covered someplace but I can't seem to find it. My ac seems to not shut down once it has achieved the desired temp. For example, I have the fan on auto and the temp on the ac set to 70 cool (not cool / heat). The ac never shuts off and just keeps getting colder until which...
Guys I can't seem to figure out what I would expect is something easy (hopefully)! The bilge switch on my dash does not light up nor does it turn on the bilge pumps. Both bilge pumps however do work but only via their float switches which means to me they have current and do work.
I read there...
While underway with the family last week the admiral mentions to me she smells gas. Her ability to pick up smells is an entire different post but,... Anyway, I stop the engines, open the hatch (Darwin Award candidate?) to find I had fuel in the bilge (never good!).
long story short, the O ring...
I have read a ton of threads on all the issues with the cool fuel models but non that seem to address (probably missed them) my problem. It appears that my starboard engine is leaking fuel right at the quad ring (the "O" ring that seals the fuel line to the cool fuel module). It appears a pin...
I am looking to make a subtle upgrade so up I have additional data available. I currently have the sc1000 gauges and curious if anyone with twins has replaced their speedo with a mermontior? Will it prove data for both engines or do you have to buy two at which point I think I would not do it...
Tried to run the generator for first time this season. Started up and ran for about 15 seconds (roughly) and shut off. LOC error 62. So I then:
Changed the impeller (old looked to be perfect), no luck - same error
flushed the fresh water side, no luck - same error
checked thru hull (seemed it...
Anybody know where I can buy a can or a match available at Home Depot / lowes? I can't get any hits on Google and want a small can for a couple spots (yes I am anal).
I have read both manuals and can assume it is in the aft berth area? It appears the screen is on the port side of the berth. Am I correct? How do you clean the screen?
Hard to explain what I am trying to do so hopefully I do an ok job
Our docks have 50a hook ups. I have a single 50a to 30a adapter and I a 25' 30a cord. I have two 30a(s) on the boat (microwave/ stove on one side and ac / other stuff on other). The question, if I bought a 30a to 30a Y adapter...
All,
other than sea trial, I haven't been able to get out on the boat so trying to learn as much as I can to keep me from going crazy with this weather! anyway, in the below pic, what is the vent suppose to do? 340 it opened the air vent on the window but this boat has a manual vent. Is this a...
All,
new to me 350 and I am hoping this is an easy question. How do the cabin blinds stay up? These are the accordion style above the galley and the side bench. I push mine up and they slowly come back down. Is there something that holds them up? I notice a clear plastic tab and I don't know...
Anyone know where I can find replacements? I used the Parts Manual (sea ray) and i can't seem to get any hits. I did google searches and can't seem to find who makes them.
Thanks in advance!
I am looking to purchase new canvas for a new to me boat 2008 350 (now called the 370). (PS:great lakes has 25% off right now). I called great lakes and they can't seem to answer the question I have around the canvas. So figured i would ask the forum.
Background of question: For the aft canvas...
Sold my 340 last year and in the process of buying a new boat. Had a survey and will try to be short.
Boat: 2008 350 (the new 370)
engines: 8.1 HOs (under 200 hours)
bottom: hulled and power washed pre-sea trial (aka clean), running gear clean (prop speed but older)
Engine tests: compression...