Hello all, I have a 1994 330DA. The shower grab rail came loose from the shower wall in the head. The bolt under the sink is still attached. The bolt seems to inaccessible from inside the head. Other side of shower wall is the forward berth. Does anybody know how to access this bolt?
Thanks for posting.
A related question for these wiper blades.
What is the best way to make sure the nuts do not come off?
I've had mine loosen a few times.
Time to revive old thread :D.
I would like to replace my louvered vent with S.S.
Are these still being offered?
My vents are the same as Pyro's, 14" x 5 5/8".
I am about to purchase. My old plotter is Furuno circa 1999/2000. I do not have radar and would eventually would like to add this as well. I am not sure my old transducer will work [I am terrible with electronics]. My dead rise is 17°. What transducer should I use?
thanks,
Regards,
Dave
It was rotting from dock water inlet and wash-down spigot to the first access panel inside of wet bar storage area.
I did find some pics from my old phone.
I tried to down load to photo bucket but I got errors.
I just went through this 2 winters ago on my '94 330 [same boat as '91 310].
I removed the helm & wet bar.
I took the complete helm seat apart, however this was unnecessary as the bolts holding it down where accessible [at least 2 in mid berth, don't remember how many bolts exactly].
The coaming...
Look for rot in coaming bolster where the dock water inlet and cock pit wash down spigot is.
Mine was rotted but it was fixable. I had to pull helm seat & wet bar. Replaced complete coaming with MDO plywood and had reupholstered.
Took several weekends. Swim platform is also susceptible to soft...
My '94 330 the salon berth uses the extra large table that is stored under the front berth.
This supports the cushions.
The cushions are not symmetrical, the shape of the berth is almost triangular.
I have image from parts manual, but I am having difficulties uploading it.
Try Searay.com and get...
Sorry for late reply.
To lube steering cable, Per the operating manual I used Quicksilver 2-4C multilube on the exposed end [don't remember but I think I turned rudder all the way to port].
I also lubed all pivots points with SAE30W.
Regards
My steering was stiff when I first purchased boat.
I followed the recommended maintenance and lubed the cable at the rudder tie bar.
it has been 100% better.
I've had some work done by Northcoast Canvas [Northcoast Marine Specialties] on RT. 53.
I am happy with their work.
they have done both my canvas and upholstery.
http://northcoastcanvas.com/
Regards,
I looked into this before by looking at '90 to '94 310/330 boats on Boat Trader.
I've seen them in mounted in a hole on the side of wet bar under the back bench seat [they didn't have ice maker or ref.].
you have to be good at cutting fiberglass.
one person made a box under the bench seat but I...