Search results

im also interested if you still have it

its time to replace my bubbleback enclosure, taylormade or ameritex or lippert are unable to help due to the age of my 320 sundancer, 2003. my current one came from a Club searay member. by chance, anyone got one for sale?

exhaust manifolds showed no visible pressure on a 0-15 psi glycerin filled gauge. so either i have live with this weaker engine or pay someone to redo everything i already tried.

well after a busy few weekends finally got to work on the boat. regapped the plugs to .038ish, double checked distributor rotor location, it looked off a tooth so i pulled it and reinstalled, i felt confident it was fixed, but no. had a mechanic tweak the cap with underway to see if rpms came...

I thought that procedure was for boats with catalytic converters that are throwing misfire codes?

i swapped KS from the strong engine to the week engine, no change, i have a HVS distributor (flat cap) this cap only controls phasing, the crankshaft sensor controls the timing i think, not an expert; thats why im asking

possible i can check

i did remove it from the block but left it connected. i grounded it with an alligator clip just in case, i got an alarm sound by doing this.

i feel your frustration, i have twins also v drives, one engine will run 4600-4800, the other wont get over 4000. diacom software clearly shows my timing is being retarded TO 24 DEGREES. but i cant find the cause, im not getting any alarms, fuel economy is bad. been struggling with this for...

what is the proper sealant?

thankfully the machine screws still had the nuts attached inside the bilge, so i was able to turn them right out. screw length was 2". i prepped the surface of both the hull and exhaust outlet. 3M 5200 and new screws, im back in action

i have 3 sheared off 1/4-20 machines screws in the hull. one screw was holding on the underwater exhaust outlet. anyone with experience with re-attaching it? or how the factory attaches them?

Still have the fastback enclosure?

Taylor Made is not selling these anymore, contract ended with the inventors they said. Where can I find one for my 2003 model