Search results

REDUCED-1990 Searay 310 EC $29,900 This boat is "my baby" and has had a lot of TLC completed on it. The interior cabin area has all new high quality carpet and vinyl. It has microwave, electric stove and the fridge was just rebuilt. The A/C is good and cold. The vinyl in the cockpit area is...

I just had a non Searay service tech replace the impeller on my genny....evidently it was completely done since i didnt have ANY water flow when the genny was running....and it didnt stay running long either..... The job cost me $400....Does this sound abut right or is it high? :huh: It...

I have a 310 EC and the little chains that keeps the gas caps from falling into "the drink" have both broken off right were they get into the little clamp thingy...is there a something, maybe like a v shaped spring wire perhaps, i can use to re-attach these chains??? I sure dont want to have to...

Well I am at a loss......not that this would take much..... :smt021 ....I thought my electric dual trumpet horn was shot because all it would do is make a strange niose when you hit the button.....its ahrd to describe....like its trying to sound, but cant.....SO, I replaced the horn(tested pror...

I have a 1990 Searay 310EC....Last time i used the Kohler 5 kw geny i noticed the discharge was a littel weak and occasionally would steam a little. Now, when i fired it up for excersize, I noticed there is ZERO discaharge and after a few minutes the system shut down. :huh: I dont know squat...

When i am using my windlass to retrieve the anchor, frequently the rope will hang up on its way into the locker. Soemone then has to go below to pull it into the locker....Could it be the rope is just old and getting a little too stiff ? :smt038 It doesnt seem to be overly stiff but this is...

Well, from a previous post it sees the Porter Cable polisher is pretty popular. I am SOOOOOO glad I wont be renting a buffer this year....oh the soreness ! ! ! :smt021 So now, what brands of polishes/waxes/cleaners do you guys like? With the weather finally cooking off, my thoughts turn to...

A while back, I added a chart plotter to my electronics on my 1990 310 EC. When I tried to fish the antenna cable thru the arch, I ran into a bad problem. The holes between the radar arch and the hull are not even close to being in alignment….Therefore; I couldn’t run it like that and made...

I have a broken nylon (plastic?) zipper on my Isenglass. The little tab at the bginning of the zipper came off, which lets the ends separate, and the zipper itself is coming open. I cant seem to get the zipper closed and open the right way so i can remove it to get it fixed. I dont want to force...