Search results

I had three screws holding wood bottom to cabinet, then 3 more holding coffee maker to that board. Ended up cutting wire and taping ends until I can locate plug. Manual says it's tied to the gfi outlet under the microwave but receptical empty of plug.

did you get advise on removing cabin doors to remove refrigerator? Mine failed and I'm against this removal challenge

a peculiar noise is heard from starboard drive when going to neutral from either forward / reverse while docking,(600 rpm's +/-). The sound is brief and stops when shaft / transmission stop turning. Hard to verbalize the sound or spell it out but its an "ERRRRR". Sound is louder on swim platform...

Attached are dwgs Taylor supplied

last year on a 2000 380DA. Parts manual called out two different P/N's: one for screw cover along side windows and windshield and one for screw cover under windshield vent. Contacted Taylor Made and they supplied correct P/N's the side window and windshield for the 2000 model year; Side windows...

Replied to this as a new post sorry but we did last year

last year on a 2000 380DA. Parts manual called out two different P/N's: one for screw cover along side windows and windshield and one for screw cover under windshield vent. Contacted Taylor Made and they supplied correct P/N's the side window and windshield for the 2000 model year; Side windows...

Over simplified but any possibility you have cockpit door open underway? Simple but many of us have sailed with that open and the fumes pull right in...

BTW anyone change Rochester fuel sending units on their 380? Sea Ray P/N 1691486 but having issue finding OEM. Any unforeseen issues with removal? Appreciate any sourcing suggestions and /or replacement issues

Reddog here’s a snap of finished product.

Morning, with respect to SeaRay logo on seat backs, your upholstery shop can duplicate that stitched insignia. Or the shops I have talked with can. Best wishes on finding a capable upholstery shop.

True the entire cockpit with a two colors is approx $4k. My backs and helm seating are in good shape. Seam on aft cushion was separating so there ya go! Mine is a partial. I also did all removal / install myself so may have saved a bit

Recovered my cockpit seat cushions in June 17, very good match however the grain was diminished compared to original. Can’t notice difference when installed. 5 cushions covered for under $700. I used a local marine upholstery company. DBA Overboard Design in Buford, GA

anyone replaced anchor on 2000 380da? Tried 35# delta but does not fit davit / chute. I'm told South Coast Marine made plow anchors for several model years. anyway to confirm based on HIN and or Hull number. Parts manual specifies P/N 878512.

Anchor lost on 2000 |380da; trying to replace; 35#Delta does not fit davit / chute; Im told South Coast Marine made KODIAK anchors for severl models; How can I confirm this was anchor on my vessel. Parts manual specifies P/N 878512. Any Sea Ray contact number that can verify anchor used based...

Pro nautic without question

Having replaced my mechanical governor the generator fails to come up to speed under load and therefore low Voltage, a/c units wont run etc. Anyone understand the adjustment procedure for these mechanical Westerbeke Genset governors? The manual indicates adjustment for surging, etc. but Im...

had vibration on starboard engine also. WOT was 300 rpm less than port. Activity rebalance and true both props; change cutlass bearings; align shaft. $4000.00 later still had vibration and I don't now from marina techs! shared this with a retired SeaRay mechanic who suggested replacing plugs...