Hello Everybody, I am happy to see this forum is still going. We are enjoying our 4th Sea Ray. We have had 240, 290 and 340 Sundancers. Now we are loving our '87 300 Weekender. Raw water cooled 270HP Crusader 5.7 direct drive inboards. I have a quick question. I don't see strainers on the engine...
Hello All,
I am essentially at my wit's end and am ready to call in the (expensive) professionals. Recently bought the boat. Twin 7.4L MPI Mercs L29 engines with MEFI3 electronics.
This engine is serial number 0L300761
From day one it has started and run fine at idle. In the off season I...
Thanks for all the quick replies. How about the berth in the bow? I am 6'2". Admiral is 5'9" Will our feet hang off the end? We had a '96 290 and enjoyed it very much. We are looking to stay that same boat size but get twin engines and A/C. Also looking forward to forward facing arch so I can...
Hello Everybody, I searched and really didn't find an answer so I am going to post it as a new question. I'm sure it has been discussed before so if someone can drop a link to previous discussion that would be great too.
I am considering a 98-2001 290 Sundancer. I am concerned about the mid...
Hello All, I’m shopping (more accurately dreaming by looking online) for a 99-01 310 Sundancer. My question is why do some helm stations have separate shift and throttle levers even though they are mercruiser stern drive vessels while others have the typical mercruiser shift/throttle on the same...
Thanks for the replies guys. I thought I would be notified via email if anyone commented on my thread. I guess not. I thought I'd check back to see and here you all are.
I do think I have an issue with the automatic bilge pump. I am going to have to stand on my head to figure out what is going...
Sorry if there is already a thread on this. I did a quick search and found nothing. If there is a thread please feel free to direct me there.
1996 Sundancer 290 (Trailered boat. No slip)
7.4 Mercruiser Bravo 3
No generator or A/C
After a day on the water, after getting in on the trailer...
Hello All,
I have searched the web and CSR extensively and cannot find the answer to the following question:
Will a 94-97 Sundancer 290 on a trailer fit though a 12' high barn door?
I have read theories about adding draft down height and bridge clearance height together to determine total...
Re: 240 Da height when on Trailer
Joel,
i think your information is off by quite a bit. My 1996 240 sundancer is on a dual axel trailer. By barn has a 12' door height and I put it in with bimini's up without any problem. I have at least a foot to spare. I could measure info you want me to...
I was able to clean up all the wiring and replace my stereo through the electrical panel hole. My panel was held on by only 4 screws. Take,that panel off and you have a nice big access hole to get behind the stereo and into that entire cabinet.