2001 Sundancer 260 7.4MPI
Installed new fuel pump, old one seem to be failing, intermittently working. New one installed, boat fired right up, ran it on and off a couple times while sitting on trailer with muffs. Towed to boat to ramp and dropped in, started at dock and sputtered out after a...
Need a new fuel pump, appears I can’t get an OEM one by itself, need to buy the whole fuel cooler kit which is 836$, seems absurd. Anyone have any other options?
2001 260da 7.4mpi
I know it fits 2001 260DA, not sure what other models. New in package, ordered from Boat Outfitters. 200 Shipped or Pickup in CT (located New Haven area)
Original MEFI 3 ECM went bad, got a replacement conversion to MEFI 4 from mefiburn. Installed and boat started right up and runs great. But randomly when clicking throttle down into neutral, boat will just stall out. Starts right back up no prob. Any ideas??
Finally found a used trailer for our boat, want to adjust the bunks before trying to put the boat on the trailer. Anyone know what the spacing inside the bunks should be so they sit on the flatter parts of the hull?
Thanks
Have a Kohler 5E, need a new carb and choke. These parts new are close to 1K. Would rather buy used ones and put a little time and use a rebuild kit if needed. Having a hard time finding a shop or place with used parts laying around.
Thanks
Joe
Boat is a 2001 260DA, engine alarm was working normally, 2 quick beeps when turning the key on. Now in the past couple weeks it has seem to stop working.
I’ve spent over an hour down in the engine well looking for the dam alarm/horn, can’t find it. Am I looking in the wrong spot? Is it up...
The bilge under the stairs kicks on when the sump box is full, water shoots out the port in the side of the boat, but then anything that is left in the line comes leaking down inside the boat under the steps and outside of the sump box. My only thought is somewhere in the line going from the...
Need to get all the exterior cushions off the boat, but i cant find a single write-up, how-to, DIY anywhere on the web, or on this site. I have searched HIGH and LO. Anyone have any tips on how these things are mounted?!?! Basically im removing every padded cushion in the cockpit area...