Search results

I've got a 2000 340 Sundancer that the Raymanine RL70c just stopped working (whitescreen). I'm looking at replacing it and was wondering how you get access behind the instruments at the helm. I don't see any access panels etc. Thanks in advance!

Help accessing Chartplotter at helm. Forgive me if I've posted this in the wrong place but… I've got a 2000 340 Sundancer that the Raymanine RL70c just stopped working (whitescreen). I'm looking at replacing it and was wondering how you get access behind the instruments at the helm. I don't...

Thanks for all the great advice and info. I've been wanting to do an oil change during the "off season" and will have a mechanic check out impellers and rule gages, get new plugs etc.

Got the boat June 2014. Mechanical survey was excellent. There seems to be an equal flow of cooling water out the sides. How can I tell if an impeller is bad?

There seemed to be average water flow from both drains when we returned to the slip.

Thanks for the reposes!Our last fill was for 64 port and 68.7 stbd (genset draws from stud).

Bear with me on this… I have a 2000 340 Sundancer with the twin 454 Vdrives. We just filled up both tanks and took her out for a spin. She likes to cruise at about 3200 and we ran at that speed for about an hour min out and an hour back. The temps on both engines were rock steady at 170deg...

Thanks, Got it! For the record, the frame is held in by two screws hidden by buttons in the vinyl just below the mWave in front. The third is on the roof of the cabinet just below it.

I just bought a 2000 340 Sundancer. The microwave was dead at the sea trial and the seller gave us a new replacement. I can't for the life of me figure out where the screws are to slide the old one out! Has anyone replaced theirs? And if so, how are they held in? Thanks!