Search results

Ok so do I just push the gear and bearings all the way onto the short yoke and then tighten the nut all the way until it starts to make contact with the gear and then start measuring the rolling torque to ensure I don’t start tightening it more than it was?

In the process of changing seals on my Alpha one Gen 2 upper. Working on the horizontal driveshaft short yoke end. I have to use the rolling torque method of reinstalling the gear and bearings back on the end of the yoke and my question is, do I need to break the gear free from the bearings to...

So I had someone check my yoke where it seals and he suggests changing the yoke as it looks like it’s grooved where the seal meets it. Questions are: can the groove be sanded out? If not can I just change the yoke and not worry about the universals? They seem ok. The guy suggested changing the...

Thanks. It ended up dropping pressure so I’m going to reseal the whole upper.

I was talking about the shift shaft on the lower part of the outdrive.

Thanks. No it’s an alpha one gen 2 but I believe your description is the same as how mine works. So far pressure dropped about 1 psi. So I’m guessing the seal will need to be replaced. Hopefully pressure testing after that will not drop any to confirm it was the issue. also I just replaced the...

I pulled my outdrive planning to just store it inside for the winter but (not) to my surprise I found a pool of gear oil in the bellows. I say not to my surprise because all season I have had small amounts of oil in the bilge. The remote oil tank also ran low so now I’m pretty certain it’s gear...

Yes it reacts to magnet so I’d say you’re right. Manifolds and risers are probably shot. That being said could these pieces of metal be lodged anywhere else after they would have exited the riser/elbows that I would need to hunt down? Sorry noob questions I know. I believe there is a Y pipe and...

Not sure if it’s rocks or giant chunks of rust?? Found this around the outside of the impeller housing when I split the outdrive to change the impeller. What is it? How did it get there?? Also noticed when pumping antifreeze through the starboard side of the bellows had less output of the...

To run the winterizing mixture from a remote fuel tank. Blaster, if I do it this way do I just fill the fuel filter up with the 2 cycle oil? I believe the manual says to run for a certain amount of time... how can I be sure that I don’t use up all the oil in the filter and then end up running...

Just got a 2004 200 sundeck this summer and going to winterize myself. Just trying to figure out the best way to hook up a remote fuel tank to run the winterizing cocktail through the motor. There is a hose that comes from the top of my fuel tank and runs to the electric fuel switch, from there...

In the galley? There are 2 screws under the overhang, once you remove those 2, the whole tv will slide out on the piece of wood its mounted on... We took the finished shelving from a broken shelving unit...

have a 1997 370 Sundancer, looking to replace the radio remote control on the dash. Can anyone explain where to locate any access hatches to assist in snaking the wire? Also I understand there is an amplifier for the rear speakers, does anyone know that location?