I have a 1976 SRV 240 weekender.
Window is taylor made. They don’t have the exact vinyl available anymore.
Ideas on who might?
this is 3/4” wide.
They got me a sample of 1” that can work with a little trimming.
getting ready to fire up the new motor.
It’s got gas and spark and is ready to go.
Question.
Block is dry, should I fill water through the t stat housing before firing up? Or will the impeller and muffs get it done quick enough?
Thanks
Hey folks.
The rebuilt 351 in my 1976 SRV 240 Weekender is in and almost ready to fire.
Onr thing I am wrestling with is a throttle cable bracket.
Original motor was 2BBL carb, Now equiped with an edelbrock 4bbl carb and intake.
Am I going to have to fab something up (an option) or is there a...
I have a 1976 Searay SRB 240 weekender.
It has a 351 Ford motor. And if a pre alpha. Type MC ? I believe it’s called outdrive.
I think the alignment bar I bought is tooo large a diameter. it’s as big as the of of the spline in the out drive. I think it needs to be smaller than the diameter at...
Probably been asked before. But as I am rebuilding the stringers and deck on my 1976 SRV 240 Weekender. I wonder, why not build some rod lockers or other storage into the below deck area of the boat?
Is flotation foam a requirement on a 24 ft boat??
Thoughts?
Hello all!
Been reading posts for a bit, time for me to start my own.
I recently took ownership of the above boat sitting on a 2004 5Starr Tandem trailer. Initial investment 0$.
To date I have pulled all of the cabin components (benches, storage, engine cover etc.). Pulled motor and outdrive...