Search results

Thanks for the article.

What is the difference between the old and new?

That’s a great idea.

Awesome!!

Looks awe gdavis67: Could you possibly post more pictures of you L shaped couch? I am planing on doing something similar. Thanks

Looks awesome!!

Post some pictures of the new vinyl. At this point I am going to leave the panels starboard. I like the look. I may change my mind when I start to redo the vinyl. I want to build an L-shape lounge down the port side and across the transom to the door before I make a move on the Vinyl work.

Finally started on the Starboard panels and received the new fresh water tank. Pleased with both. Here are a few progress pictures.

I'll post pictures for sure.

Let the new panels begin,,,a little marine board action.. I do believe I’m at the point where I need to get everything back together before I start another project, lol! I’m still waiting on my fresh water tank.

Great information, I'm looking at the Sea Blaze x spectrums. Is it possible to send some pictures of your install? Thanks

What LEDS did you go with? I've been looking at the Sea BlazeX Spectrum. They seem to be simple to install and use.

gravies67 I will also be adding a set of tabs. Did you install them yourself? They look good.

No prob gdavis67. I ended up going with a stock tank from National Tank Outlet. I did add fittings but was not hateful. It is a 55gal 46x28x11, about half the size of the aluminum tank. The fittings are on the end of the tank versus on top. That way I can slide the tank forward and out...

So I have the older electronics and a somewhat newer Garman on my boat. I’m thinking I would like to update the electronics maybe for next season but what would make more sense? I’m looking at the Flir M-series night vision. I almost think I would prefer to go that route over a new radar...

That looks great!! I received my quote and was a bit taken back. So I decided to look for another supplier. Thankfully I found one. The only difference is the inlet fittings will be on the end of the tank. I’m ok with the location since I’m keeping the tank off the bulkhead a foot for...

Hello Ricochet, Did you get your poly tank installed? How was the quality? Dura Weld is getting a quote to me for my tank hopefully tomorrow.

Thanks for the info. I cannot find Pietro's build thread for some reason. LoL