SOLVED!
Can anyone tell me what the heck this is? Had a service last month and only just noticed this yellow plastic doohicky on the end of a small hose sticking out. What is it? Any help would be greatly appreciated!
I have a feeling its for the speedometer...since I noticed that its...
The Long Island Boaters Club has a great youtube channel with lots of clear videos for basic maintenance, etc.
Here's one for the Bravo III zinc replacement:
http://www.youtube.com/watch?v=Dw363E9HBQo
Getting ready to replace mine this week...its a big help.
Cheers,
Dan
Hi all- just curious what everyone's thoughts are. I can't remember off hand but I believe I have 3/34" zincs on my trim tabs (salt water boat).
Boatzincs has several different sizes. Does it matter if they are slightly larger (4 inch) or smaller (2 13/16 inch)?
boatzincs.com/rudder
EDIT-...
Any tips for quick troubleshoot/repair? Drives me nuts anytime we hit a wave the door slides open and bangs shut!
Otherwise I'll have to replace it. If so, I've checked out fpmarine.com but am not sure which hardware is correct. They have a TON of latches. (Which would fit a 2004 240...
Well, my 04 Sundancer 240 also fell victim to those crappy faulty EIM and/or switchpads that SeaRay finally stopped selling.
It appeared last year that my freshwater system was inop. Replaced my freshwater pump, and of course it still didn't work. After close scrutiny, it turns out the...
Well, I'm in the midst of fighting to get reimbursed for gelcoat cleaning/repair and outdrive inspection. My boat was blocked in a wet slip for two months at my marina onboard Naval Air Station Pensacola. So I had that much muck, oil, and barnacle growth on the bottom and in my outdrive...
Hey all-
Mine went bad it seems. Just wondering if anyone had a spare starboard switchpad so I could test whether its the pad or the Elec Interface Module that went bonkers?
Here's the part number:
1718632
MODULE, ELEC KEYPAD W/BCKLT BURL RV5 (with backlight, burl finish)
Thanks!
Dan M.