Search results

Short story short...I need a new intake manifold (non vortec) for my 92 mercruiser 4.3. Cant find any decent used ones and see edlebrock has a marine application (2111). Anyone know any special parts I need to do this swap? Such as special intake bolts or edlebrock specific carb (HOPE NOT CAUSE...

Hi all! I have a 92 mercruiser 4.3 in my 230 Sundancer. The thermostat housing is rusted out and looking for a replacement. Maybe me is stamped 16413-c. I see some for sale that look the same but say are 97110. Is there a difference I don’t see?

Hi all, Yes I know this may be a stupid question but am in hopes of it being positive. I have a 92 230 sundancer and am trying to find a cockpit cover without success. I saw someone parting out a90 220 DA with a nice bimini and full camper enclosure. By any chance, would this fit onto my 230?

Hi all ..well after a year I wanted to get my 1992 sundancer 230 ready for the upcoming season. Never had it in the water since I got it but did replace the lower unit. Long story short, the motor is siezed, pulled plugs (rusted looking), put a breaker bar on the crank but and it won't budge. So...

Hi all, I'm replacing the flappers on my 4.3 merc but don't think they're fitting like they should. I wire brushed and sanded the tubes to smooth them to remove the hardened gunk from the overheat condition when I bought the boat. I squeezed the flappers together, inserted them in the tubes and...

Hello all, On my 92 sundancer 230, the step just inside the cabin door had rotted. I built a new step, not a problem but have a question about mounting it. On the back there was a piece of wood that appeared to been screwed to the back side which the step rests on. How is the best way to attach...

Hello all, Wanted to run something by everyone. Bought my 230 sundancer with a 4.3. previous owner said it overheated on a sea trial. I removed the lower unit to replace the impeller and found the flappers in there (so I know I need to replace those as well). One bolt of the water housing won't...

Well I removed the alpha 1 gen 2 lower unit to replace the water pump. When I separated the lower half, three small triangular plates fell to the ground along with a piece of rubber (looks to been part of a seal). Any idea on the three plates?

Hello all, I have a 1992 sundancer 230 with a 4.3 engine and from what I can tell the Alpha 1 gen 2 outdrive. Looking to get an impeller kit and see many out there. Some sites are saying some of the kits fit from serial number XXX and up. So...I'm guessing there are different kits for different...

Hi all, looked into the owners manual thread without success. Want to get an owners manual for a 1992 sundancer 230ltd. Tried the Sea ray site and my models not listed. Also, had a question about the fridge. Can't seem to find how/where it turns on though I'm having a sneaky suspicion is just an...

Just picked up a 92 sundancer 230. Can't wait to get her into the water. This type of boat is completely new to me as I've only had outboards before. Looking to start off with trying to find an owners manual...not much luck as of yet

Hi again all, Can anyone tell me the difference between a 1992 230 and 240 sundancer? I'm assuming the first two numbers designate length, but what about layout, amenities and such? Thanks

Hi all! Looking into a 1988 weekender 268. Has twin 4.3, one runs, owner "thinks" other needs a starter. Has a dual axle trailer (no title) asking $3000 obo. Not sure if this would be a good deal, though thinking of offering $1800-2000, depending upon inspection. Also my tow vehicle is a 2001...