Search results

Mine is powered by the gfi in the cockpit to the left of cabin door down low. hope that helps, Rob

Thank you! I will give that a try tomorrow. I didn’t want to pull too hard and break it! Thanks lots of great info on this forum!

I have a question, I have searched to no avail. Does the salon sofa bottom slide out to make a bed? Mine seems like it wants to move but is hung up in the center. Is there a lever to pull? Etc. thanks

Btw I forgot to change my boat info, its a ‘07 44DA

Does anyone know how to pull out the salon sofa to make a bed? Mine is stuck, I assume that it does slide out? Thanks

I will check it out, never liked the way Mercruiser piped the water thru the stern anyway. Sounds much more efficient. I wonder why you couldn’t have both with a tee fitting? Maybe the drives would starve?

That makes sense, I understand the thru hull and block off plates but dont understand the showers? Is that a spray onto the outdrive?

Not sure on the actual weight but the Gross weight rating for the trailer is 20,000 lbs. I’m pretty sure its about maxed out with the weight of the trailer and boat. I think the truck is rated at combined 28,600lbs.? Hard to read the charts but it pulls well and stops well. When I flush...

Thanks for the info M Prod, although I think that applies to V drives? Mine is stern drive and from what I remember the sea water pumps are pretty accessible. The PO lost an impeller on port side and believe it or not had only that one changed? Now that engine runs about 10º hotter than...

Thank you, it actually pulls very well other than being wider it kinda feels like pulling a fifth wheel. The truck is an F-350. Being in AZ we will probably slip her at a local lake and be taking trips up to Lake Powell annually which is where I bought it. Hard to find one with a trailer and of...

Just brought home my new to me ‘06 340 DA Lots of work to be done before she goes in the water again. Thanks for all the info on this site